Skip to content
Omnikalc

How long should sawhorse legs be?

Enter the sawhorses, the working height, the beam length and depth, the leg splay angle and the lumber length: get the leg length, the spread at the feet, the lumber per sawhorse and the lumber pieces to buy.

Updated on
Your inputs

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

°

Value out of range

in

Value out of range

Results

Leg length

28.3 in

Lumber pieces to buy

4

Cut both ends of each leg at the splay angle so the feet sit flat, add a cross brace between each pair of legs, and set the height a little below your knuckles with your arms down
Spread at the feet
18 in
Lumber per sawhorse
149.4 in

A pair of sawhorses is the first project in many workshops: a beam, four splayed legs and a couple of braces, cut from a few lengths of 2 × 4. Getting the leg length right is the tricky part, because the legs lean outward in two directions at once. This calculator works out the leg length, how far the feet spread, the lumber per sawhorse and the pieces to buy.

How the calculation works

  • Vertical height of the legs = working height − beam depth
  • Leg length = vertical height × √(1 + 2 × tan²(splay angle)), for legs splayed equally sideways and endwise
  • Spread at the feet = beam depth + 2 × vertical height × tan(splay angle)
  • Lumber per sawhorse = beam length + 4 legs
  • Pieces to buy = sawhorses × lumber per sawhorse ÷ lumber length, rounded up

Two sawhorses 30 in high with a 36 in beam of 2 × 4 (3.5 in deep) and legs splayed 15° each way need legs about 28.3 in long. Their feet spread about 18 in across, and each sawhorse takes about 149.4 in of lumber, so buy 4 lengths of 8 ft, plus a little extra for braces.

Choosing the height

Use Height
Cutting sheet goods with a circular saw 24 to 30 in
General work, about knuckle height 30 to 34 in
Detail work or tall users 34 to 38 in

A good rule is just below the knuckles with your arms hanging at your sides, the same height as a workbench for heavy work.

Building tips

  • Cut both ends of each leg at the splay angle so the top meets the beam flush and the feet sit flat.
  • Attach the legs with screws and construction glue, or use metal sawhorse brackets for a quick, foldable build.
  • Add a cross brace between each pair of legs about a third of the way up, and a shelf if you like.
  • Wider splay is steadier but takes more floor space; 10° to 15° suits most shops.
  • Make them in pairs at the same height so a door or sheet of plywood lies flat across them.

Frequently asked questions

How long should sawhorse legs be?

For a 30 in sawhorse with a 2 × 4 beam and 15° splay each way, about 28.3 in.

What angle for sawhorse legs?

About 10° to 15° each way; 15° gives a spread of about 18 in at the feet for a 30 in sawhorse.

How much lumber for two sawhorses?

About 149.4 in each, or 4 lengths of 8 ft 2 × 4, plus a little for braces.

How tall should sawhorses be?

Just below your knuckles with your arms down, often 30 to 34 in; lower for cutting sheet goods.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.