Skip to content
Omnikalc

Shellac cut calculator

Enter the cut you want in pounds per gallon, the volume of alcohol and the thinner cut for a coat to get the weight of flakes, the concentration by weight and the alcohol to add for the thinner coat.

Updated on
Your inputs
lb

Value out of range

fl oz

Value out of range

lb

Value out of range

Results

Weight of flakes to dissolve

4.0 oz

Alcohol to add for the thinner cut

16.0 fl oz

Concentration by weight
23.3 %
Volume of solution produced
19.6 fl oz
Alcohol in the thinner mix
32.0 fl oz

The shellac cut calculator gives the weight of flakes to dissolve in a given volume of alcohol for a chosen pound cut, the concentration by weight, the volume of solution and the alcohol to add to thin a mix down to a lighter cut.

How the calculation works

  • Enter the cut wanted in pounds per gallon and the volume of alcohol.
  • Enter the thinner cut you want for finishing coats.
  • Read the weight of flakes, the concentration and the alcohol to add.

Example

A 2 lb cut in 16 fl oz of alcohol takes 4.0 oz of flakes, a concentration of 23.3 % by weight, and makes 19.6 fl oz of solution. To thin it to a 1 lb cut, add 16.0 fl oz of alcohol, for a total of 32.0 fl oz of alcohol.

Why it matters

The calculator helps woodworkers, furniture restorers and luthiers who mix shellac from flakes, want repeatable results from one batch to the next, and need to thin a stock mix to the cut a particular job calls for.

Good to know

Use fresh flakes and denatured alcohol with little water, since water makes the finish cloudy. The weight of flakes is measured on a scale and not by volume because flakes pack differently. The concentration by weight depends on the density of the alcohol, taken here as 0.79 g/mL. The cut is nominal: real flakes contain some wax and moisture. Shellac is often used as a sealer, so a lighter cut under other finishes helps adhesion. Mix only what you will use in a few weeks, work in a ventilated place away from flames because the alcohol is flammable, and keep the jar closed between uses so that the alcohol does not evaporate and raise the cut.

The wood finish calculator estimates other coatings, the wood moisture calculator checks the lumber, the deck stain calculator handles exterior coatings and the glaze batch calculator mixes glazes.

Frequently asked questions

What does a pound cut mean?

A pound cut is the number of pounds of shellac flakes dissolved in a gallon of denatured alcohol. A 2-pound cut means 2 pounds in a gallon, or about 4 ounces in a pint of alcohol. A higher cut builds a thicker film per coat, and a lower cut flows and levels better.

Which cut should I use?

A 2-pound cut is the usual choice for brushing and a good all-purpose mix. A 1-pound cut is typical for padding, French polishing and thin coats, while a 3-pound cut suits a sanding sealer or a single heavy coat. A cut of 4 pounds or more is hard to apply without brush marks.

How do I dissolve the flakes?

Put the flakes in a glass jar with the alcohol, close it, and shake it from time to time. They dissolve in several hours, faster with fine flakes and gentle warmth, never with an open flame. Strain the solution through a paint filter to remove wax and dirt, and label the jar with the date and the cut.

How long does mixed shellac last?

Liquid shellac slowly loses its ability to cure and is best used within six months. Dewaxed flakes can be dissolved when needed and keep for years dry. Test an old batch on a scrap: it should be dry to the touch in an hour or less. If it stays tacky, the batch is too old.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.