Skip to content
Omnikalc

Time-lapse calculator: what interval should you shoot at?

Enter the length of the event, the length of the clip and the frame rate to get the interval between photos, the number of photos and the storage needed.

Updated on
Your inputs

Value out of range

s

Value out of range

MB

Value out of range

Results

Interval between photos

20.0 s

Number of photos to take
720
Speed-up factor
480 ×
Storage needed
18.0 GB

A time-lapse squeezes hours into seconds, and the maths of it is the same each time: how many photos, and how often. This time-lapse calculator takes the length of the event, the length of the clip and the frame rate to give the interval between photos, the number of photos, the speed-up factor and the storage needed.

How the calculation works

  • Photos needed = clip length × frame rate. A 30-second clip at 24 frames per second needs 720 photos.
  • Interval = event length ÷ photos needed. It is the time between two shots, so that the whole event fits the clip.
  • Speed-up factor = event length ÷ clip length. A factor of 480 means that one second of film shows eight minutes of real time.
  • Storage = photos × file size of one photo. Raw files are larger than JPEG files, and the figure helps to choose the memory card.

Example

You want to film 4 hours of a sunset and clouds as a 30-second clip at 24 fps, with photos of 25 MB. You need 30 × 24 = 720 photos. The interval is 4 × 3,600 ÷ 720 = 20 seconds, the speed-up factor is 480, and the photos take 720 × 25 ÷ 1,000 = 18.0 GB on the card.

Why it matters

Photographers, videographers and builders use the figures to plan a shoot before they leave. The interval decides how the motion looks, and the number of photos and the storage tell you if the memory card and the battery last for the whole event.

Good to know

The calculator gives the interval for a clip of an exact length, but real shoots need a margin: start earlier, finish later and cut the clip down in editing. The file size depends on the camera, the format and the compression, so use the size of a test photo. Frame rate and playback speed can also be changed in editing. The result does not set the exposure, which depends on the light, the lens and the shutter, and the interval must always be longer than the time the camera needs to take and save a photo.

The video file size calculator estimates the size of the final video, the photo storage calculator counts the space for your pictures and the astrophotography exposure calculator helps with night skies.

Frequently asked questions

How do I choose the interval?

Divide the length of the event by the number of frames you need. A moving subject such as clouds works well at 2 to 10 seconds, traffic and crowds at 1 to 3 seconds, a sunset at 5 to 15 seconds, and plants or a building site at minutes. A shorter interval makes smoother motion and a longer one a more dramatic effect.

Which frame rate should I use?

Most clips are played at 24, 25 or 30 frames per second. Use the rate of the rest of your video project so the clip fits. A higher rate needs more photos for the same length, but the motion looks smoother.

How should I set the shutter speed?

The exposure time must be shorter than the interval. A shutter time of about half the interval gives a natural motion blur that makes the clip look smooth, and a very fast shutter gives a choppy look. In bright light a neutral density filter helps to keep a slow shutter.

Do I need to count the battery?

Yes. A long time-lapse can use many hours of power, so use a power adapter or a battery grip, and check that the card has enough space. Also turn off automatic exposure changes in the camera when you can, since they cause flicker.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.