Skip to content
Omnikalc

Elliptical skin excision planning calculator

Enter the diameter of the lesion, the margin around it and the length to width ratio of the ellipse to get the width and length of the excision, the angle of the tips, the skin removed and the length that gives a 30 degree tip.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mm

Value out of range

mm

Value out of range

Value out of range

Results

Length of the excision

48.0 mm

Width of the excision (lesion plus both margins)
16.0 mm
Angle of each tip of the ellipse
37 degrees
31 to 45 degrees: acceptable, but a standing cone may form, so a longer ellipse is better
Skin removed (approximate area)
384 mm²
Length that gives a 30 degree tip
60 mm

The elliptical skin excision calculator gives the width and length of an ellipse around a lesion, the angle of the tips, the skin removed and the length that gives a 30 degree tip, from the lesion diameter, the margin and the ratio.

How the calculation works

  • Enter the lesion diameter and the margin on each side.
  • Choose the length to width ratio.
  • Read the dimensions and the tip angle.

Example

A lesion of 8 mm with 4 mm margins needs a width of 8 + 2 × 4 = 16.0 mm. At a ratio of 3:1 the length is 48.0 mm and each tip has an angle of 2 × atan(1/3) = 37 degrees, which is acceptable. To reach 30 degrees the ellipse should be 60 mm long.

Why it matters

The calculator helps dermatology and surgery residents, general practitioners who do minor surgery and students who learn how to draw an excision before the incision.

Good to know

The geometry is that of a fusiform shape with straight sides from tip to tip, in which the half width is the opposite side and half the length is the adjacent side of the angle at the tip, so the angle is 2 atan(width / length). At 3:1 this gives 37 degrees and at 4:1 it gives 28 degrees, which is the reason why textbooks advise a ratio of three to four. In real surgery the ellipse is drawn with gently curved sides, and its long axis is placed along the lines of least tension or the relaxed skin tension lines of the area, to leave the thinnest scar. On the scalp, the legs and areas where the skin is tight, a longer ellipse may be needed, and when the closure is under tension a deep layer of sutures is used. The scar will be as long as the ellipse and not as the lesion, which is why patients must be told that a small lesion can leave a scar of several centimeters. The depth and the margins depend on the pathology, and the pathologist examines the specimen. The calculator is for planning practice and teaching.

The dermoscopy calculator scores a suspect lesion before the surgery, the graft calculator covers larger defects, the healing rate calculator follows closure of an open wound and the nail calculator estimates regrowth.

Frequently asked questions

Why is the excision an ellipse?

A round hole cannot be closed in a line without pleats at the ends. Making the cut longer than wide, usually three to four times, allows the edges to come together flat and leaves a single line scar.

What is a dog-ear?

It is a bulge of extra skin at one end of the closed wound, caused by a tip that is too wide or a closure that is uneven. It is avoided by a tip angle of about 30 degrees, or fixed by a small extension of the cut.

How wide should the margin be?

It depends on the lesion. It is 2 to 4 mm for many benign lesions and basal cell carcinomas, and 5 mm or more for other cancers, according to the guidelines and the pathology.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.