Skip to content
Omnikalc

Time in range (CGM) calculator

Enter the number of CGM readings in each glucose band, the mean glucose and the standard deviation to get the time in range, the GMI and the variability.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

Value out of range

mg/dL

Value out of range

mg/dL

Value out of range

min

Value out of range

Results

Time in range (70 to 180 mg/dL)

67.0 %

Time below range (under 70 mg/dL)
3.0 %
Time above range (over 180 mg/dL)
30.1 %
Time under 54 mg/dL
0.5 %
Time over 250 mg/dL
7.7 %
Glucose management indicator (GMI)
7.3 %
Glucose variability (CV)
33.3 %
Hours in range per day
16.1 h
Days of data
14.0 days

The time in range calculator gives the time in range, the time below and above range, the time under 54 and over 250 mg/dL, the glucose management indicator (GMI), the variability and the hours in range per day from the readings of a continuous glucose monitor.

How the calculation works

  • Enter the number of readings in each of the five glucose bands, taken from the sensor report.
  • Enter the mean glucose and the standard deviation.
  • Enter the minutes between readings to get the number of days of data.

Example

With 2700 of the readings in range and a mean of 165 mg/dL, the time in range is 67.0 %, which is 16.1 h a day. The time below range is 3.0 %, the time above range 30.1 %, the GMI 7.3 % and the variability 33.3 % over 14.0 days.

Why it matters

The calculator helps people who use a continuous glucose monitor, caregivers and students who want to check the figures of a report against the international targets, or who track the change of time in range from one fortnight to the next.

Good to know

Use at least 14 days of data with 70 percent of the readings available, as the consensus recommends. The five bands must be exclusive, with each reading in only one of them. The GMI is an estimate that does not replace a lab HbA1c, and the two can differ. The targets are for most adults with diabetes and not for pregnancy, children or frail older people, who have their own targets. The tool does not give medical advice and must not be used to change insulin doses, so discuss the figures with your diabetes team, especially any time below 54 mg/dL.

The A1c to eAG calculator converts between HbA1c and average glucose, the blood sugar calculator converts mg/dL and mmol/L, the insulin correction factor calculator explains corrections and the coefficient of variation calculator details the variability.

Frequently asked questions

What is time in range?

Time in range is the share of the day that the glucose measured by a continuous glucose monitor (CGM) stays between 70 and 180 mg/dL (3.9 to 10.0 mmol/L). It complements the HbA1c by showing how much of the time the glucose is on target, and how often it goes too low or too high.

What are the usual targets?

The international consensus for adults with type 1 or type 2 diabetes suggests more than 70 percent of time in range, less than 4 percent below 70 mg/dL, less than 1 percent below 54 mg/dL, less than 25 percent above 180 mg/dL and less than 5 percent above 250 mg/dL. Each 5 percent more time in range is considered clinically meaningful. Targets are different in pregnancy and for older or frail people, so follow your care team.

What is the GMI?

The glucose management indicator estimates the HbA1c from the mean CGM glucose, with the formula 3.31 + 0.02392 × mean glucose in mg/dL. It is meant for at least 14 days of data with 70 percent of readings available. It can differ from the lab HbA1c by half a point or more, because the two measure different things.

What does the variability tell?

The coefficient of variation is the standard deviation divided by the mean. A value of 36 percent or less is considered stable, and a higher value means large swings and a higher risk of lows. It is computed by the CGM software, and you can copy the standard deviation and the mean from the report.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.