Waste water, rivers and industrial effluent are tested for how much oxygen their pollutants would use up. The chemical oxygen demand (COD) gives the answer in a few hours. This COD calculator converts the blank and sample titration volumes, the FAS molarity and the sample volume into the COD in mg/L. It also gives the BOD to COD ratio and compares the result with a discharge limit.
How the calculation works
- Titrant consumed by the oxidation = blank volume − sample volume (both in mL, from the back-titration with ferrous ammonium sulfate).
- COD (mg O₂/L) = (blank − sample) × molarity × 8,000 ÷ sample volume. The factor 8,000 is the milliequivalent weight of oxygen, 8 g per equivalent, expressed in mg.
- BOD5 to COD ratio = BOD5 ÷ COD. A high ratio means that most of the organic load can be removed by microorganisms.
- Compared with the limit = COD ÷ the limit × 100.
Example
In a dichromate reflux test, the blank needs 12.5 mL of 0.1 M FAS and the 20 mL sample needs 5.5 mL. The difference is 7.0 mL. The COD is 7.0 × 0.1 × 8,000 ÷ 20 = 280 mg/L. With a BOD5 of 120 mg/L, the BOD5 to COD ratio is 0.43, so the sample is partly biodegradable. Against a limit of 125 mg/L it is 224%.
Why it matters
Treatment plants, laboratories and industrial sites report COD to follow the load on a process and to prove compliance with a discharge permit. The test is fast, so it is used for day-to-day control, while the BOD test takes five days. The ratio between the two shows whether a biological treatment will work or a chemical one is needed.
Good to know
Chloride ions in the sample are oxidized by dichromate and give a false high result, so a mercuric sulfate masking agent is added when the chloride content is above about 2,000 mg/L. Use a sample volume that gives a titrant consumption of about 20 to 80 percent of the blank, and dilute strong samples. Run the blank with the same reagents and the same heating time. The calculator assumes the standard back-titration with ferrous ammonium sulfate; it does not apply to photometric tube tests, where the reading is taken directly in mg/L.
Related tools
The dilution calculator prepares a weaker sample, the serial dilution calculator plans a series of dilutions and the molarity calculator finds the concentration of the titrant.