Skip to content
Omnikalc

What is your engine's compression ratio?

Enter the bore, stroke, number of cylinders and combustion chamber volume: get the compression ratio, the displacement in liters and cubic inches, and the bore-to-stroke ratio.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

Results

Engine displacement

1.998 L

Compression ratio

10.08 : 1

Typical of modern naturally aspirated gasoline engines; premium fuel is often recommended
Swept volume per cylinder
499.6 cc
Engine displacement in cubic inches
121.9 cu in
Bore to stroke ratio
1.00
Close to square

The compression ratio tells you how much the engine squeezes the air and fuel before ignition. It is the volume of a cylinder when the piston is at the bottom of its stroke divided by the volume when the piston is at the top. This calculator works it out from the bore, the stroke and the volume of the combustion chamber, and gives you the engine displacement and the bore-to-stroke ratio at the same time.

How the calculation works

  • Swept volume per cylinder = π × (bore ÷ 2)² × stroke
  • Displacement = swept volume × number of cylinders
  • Compression ratio = (swept volume + chamber volume) ÷ chamber volume
  • Bore to stroke ratio = bore ÷ stroke

The chamber volume (also called the clearance volume) is everything left above the piston at top dead center: the cylinder head chamber, the head gasket, the shape of the piston crown and the gap between the piston and the block deck.

Example

A four-cylinder engine with an 86 mm bore and an 86 mm stroke sweeps 499.6 cc per cylinder, or 1.998 L in total (about 122 cubic inches). With a 55 cc chamber, the compression ratio is (499.6 + 55) ÷ 55 = 10.08:1. The bore-to-stroke ratio is 1.00, a perfectly square engine.

What the ratio means

  • Under 8:1: old designs and some engines meant for high boost.
  • 8:1 to 10:1: turbocharged or supercharged gasoline engines, which keep the ratio low to avoid knock.
  • 10:1 to 12:1: modern naturally aspirated gasoline engines.
  • Above 14:1: needs very high octane fuel such as racing gas or ethanol.
  • Diesels run much higher, from 15:1 to 20:1, because they ignite by compression alone.

Changing the ratio

A thicker head gasket, a milled cylinder head or a different piston changes the chamber volume. Milling 0.5 mm from a head can raise the ratio by about half a point. Raising it improves efficiency and power but demands a higher octane rating, so check the fuel your engine can use before changing it. Measuring the chamber volume with a burette and a clear plate gives a more accurate result than a catalog figure.

Frequently asked questions

What is the compression ratio?

The volume of a cylinder with the piston at the bottom divided by the volume with the piston at the top: (swept volume + chamber volume) ÷ chamber volume.

What is the combustion chamber volume?

The volume left above the piston at top dead center, including the cylinder head chamber, the gasket and the piston shape.

Does a higher compression ratio give more power?

It raises thermal efficiency and power, but also the risk of knock, so it needs fuel with a higher octane rating.

How is displacement calculated?

π × (bore ÷ 2)² × stroke × number of cylinders.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.