Skip to content
Omnikalc

Four-parameter logistic (4PL) calculator: convert an assay response into a concentration

Enter the 4PL curve parameters and a measured response to get the concentration of an unknown sample, or the predicted response at a given concentration.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

Value out of range

Value out of range

Results

Concentration of the unknown sample

37.663

Signal as a share of the full range (a to d)
44.68 %
Predicted response at the chosen concentration
0.6945

Plate readers and immunoassays give signals, not concentrations. The four-parameter logistic calculator takes the four fitted parameters of a 4PL curve and a measured response, and gives the concentration of the unknown sample, the signal as a share of the range and the predicted response at any concentration.

How the calculation works

  • Enter the four parameters of your fitted curve: the lower asymptote a, the upper asymptote d, the midpoint c and the Hill slope b. They come from your plate reader or curve-fitting software.
  • To read an unknown, enter its measured response y. The calculator inverts the curve: x = c × ((a − d) ÷ (y − d) − 1)^(1 ÷ b).
  • The result is only valid when y lies between a and d. Outside that range the curve has no solution and the calculator flags it.
  • You can also check the forward model. The response at a concentration x is y = d + (a − d) ÷ (1 + (x ÷ c)^b).

Example

An ELISA curve has a = 0.05, d = 2.4, c = 45 and b = 1.2. A sample reads 1.10. The ratio (a − d) ÷ (y − d) is −2.35 ÷ −1.30 = 1.8077, so x = 45 × (0.8077)^(1 ÷ 1.2) = 37.66. The signal is 44.7 % of the range, and at a concentration of 20 the curve predicts a response of 0.6945.

Why it matters

Labs use 4PL curves for ELISA, dose-response and cell assays, and they need the inverse of the curve each time they read an unknown from a plate. Doing it by hand is slow and error-prone.

Good to know

The parameters must come from a good fit of standards that span the range of interest. Replicate readings, outliers and the edges of the curve all affect accuracy. Your assay protocol may also require a weighted fit, which this calculator does not perform.

The linear regression calculator covers straight-line standard curves, and the logistic growth calculator uses a related S-shaped model for populations.

Frequently asked questions

What is a four-parameter logistic curve?

It is an S-shaped curve with four parameters: the response at zero concentration, the response at saturation, the concentration at the midpoint and a slope factor. It is the standard model for ELISA, dose-response and many immunoassay data, where the response levels off at both ends.

Why does the calculator say the concentration cannot be computed?

The inverse formula only works for responses that lie between the two asymptotes. A response beyond them lies on the flat part of the curve, where any concentration would give nearly the same signal. Dilute or concentrate the sample so the reading falls within the curve.

How reliable is a reading near an asymptote?

Not very. Near the plateaus the curve is almost flat, so a small error in the signal changes the concentration a lot. The most accurate part of the curve is around the midpoint, so aim to measure there.

What does the Hill slope tell me?

It describes how steep the transition is. A slope of 1 matches simple binding, a higher value means a sharper switch, and a lower value a more gradual one. A negative slope in some software only reflects the direction of the curve.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.