Skip to content
Omnikalc

What size fuel injectors does your power target need?

Enter the target power, BSFC, number of cylinders and maximum duty cycle: get the injector flow in lb/hr and cc/min and the total fuel flow the pump must deliver.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

%

Value out of range

Results

Injector size needed (lb/hr)

31.3

Injector size needed (cc/min)
328
Total fuel flow at full power (lb/hr)
200.0
Total fuel flow at full power (liters per hour)
121.8

Fitting injectors that are too small starves the engine at full load; fitting ones that are far too large makes idling and light loads hard to control. The usual method sizes the injector from the target power, the engine’s brake specific fuel consumption (BSFC), the number of injectors and the maximum duty cycle you accept. This calculator returns the required injector flow in lb/hr and cc/min, and the total fuel flow the pump must supply.

How the calculation works

  • Total fuel flow (lb/hr) = horsepower × BSFC
  • Injector size (lb/hr) = total fuel flow ÷ (number of injectors × duty cycle)
  • Injector size (cc/min) = lb/hr × 10.5 for gasoline
  • Liters per hour = lb/hr × 0.4536 ÷ 0.745 (gasoline density in kg/L)

Example

An eight-cylinder engine is built for 400 hp with a BSFC of 0.50 and a maximum duty cycle of 80%. The total fuel flow is 200 lb/hr, or about 121.8 liters per hour. Each injector must flow at least 31.25 lb/hr, which is about 328 cc/min, so you would choose the next standard size up.

Why it matters

Injector sizing is among the first steps when building or tuning a turbocharged or modified engine. It tells you whether stock injectors can support a power target, and sets the fuel pump and line requirements for the supply system. Choosing a size with some margin avoids running the injectors out of range at full load.

Good to know

Injector ratings are measured at a standard pressure (often 43.5 psi or 3 bar), and flow changes with the square root of the pressure. Fuel type, battery voltage and injector dead time also matter. The result is a starting point to verify with a tuner and a wideband sensor; engine damage from running lean is expensive. This tool is for education.

The horsepower and torque calculator converts torque into power, the boost pressure calculator estimates the power gain from a turbocharger, and the fuel consumption calculator gives gas mileage.

Frequently asked questions

How is the injector size computed?

Injector flow (lb/hr) = horsepower × BSFC ÷ (number of injectors × maximum duty cycle). It is the static flow the injector must deliver so that it never exceeds the chosen duty cycle at full power.

What BSFC should I use?

About 0.45 to 0.50 for a naturally aspirated gasoline engine, 0.55 to 0.65 for a turbocharged one, and 0.65 to 0.80 for E85, which needs about 30% more fuel than gasoline.

Why keep the duty cycle below 100%?

At 100% the injector is always open and cannot respond to changes. A maximum of 80 to 85% leaves a margin for the fuel supply and for transient demands.

Does the fuel pump matter?

Yes. The pump and lines must supply the total flow with a margin, and the fuel pressure has to be consistent with the pressure at which the injector rating was measured.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.