Skip to content
Omnikalc

How much power does a given boost pressure add?

Enter the unboosted power, the boost and the ambient pressure: get the pressure ratio, the ideal airflow increase and the estimated power with boost.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

%

Value out of range

Results

Pressure ratio (absolute)

1.680

Moderate boost, typical of a tuned turbocharged engine
Ideal increase in air density and airflow
68.0%
Estimated power with boost (hp)
395
Estimated power gain (hp)
145
Boost pressure in kPa
69

A turbocharger or supercharger packs more air into each cylinder, and more air burned with the right amount of fuel means more power. The pressure ratio compares the manifold pressure with the ambient pressure, and gives the ideal increase in airflow. This calculator estimates the power with boost from the baseline power of the unboosted engine and an efficiency factor for the real-world losses.

How the calculation works

  • Pressure ratio = (boost + ambient pressure) ÷ ambient pressure
  • Ideal air density gain = pressure ratio − 1
  • Real power gain = (pressure ratio − 1) × efficiency
  • Power with boost = base power × (1 + real power gain)

Example

A naturally aspirated engine makes 250 hp. With 10 psi of boost at an ambient pressure of 14.7 psi, the pressure ratio is 1.680, an ideal air density gain of 68.0%. With an efficiency of 85%, the real gain is 57.8%. The estimated power is about 395 hp, or about 145 hp more than before.

Why it matters

The pressure ratio shows quickly what a given level of boost is worth, and why small amounts of boost add so much power. It also shows why high altitude hurts a naturally aspirated engine more: the ambient pressure falls, while a turbo can restore it. The same boost pressure delivers a lower ratio at high elevation, so engines need less boost there.

Good to know

This is a simple model: it does not include the heating of the charge, the effect of the intercooler, the compression ratio or the fuel quality. Raising boost without adding fuel and adjusting the ignition can destroy an engine. A professional tuner and appropriate safety margins are essential. This tool is for education.

The injector size calculator sizes the fuel supply for a power target, the horsepower and torque calculator converts between torque, rpm and power, and the compression ratio calculator covers the engine’s static compression.

Frequently asked questions

What is the pressure ratio?

The absolute pressure in the intake manifold divided by the ambient pressure. At 10 psi of boost at sea level (14.7 psi), the pressure ratio is (10 + 14.7) ÷ 14.7 = 1.68.

Why does boost raise power?

Power is proportional to the mass of air burned per cycle, and compressing the air increases its density. With a matching amount of fuel, more air gives more power. In the ideal case, power rises with the pressure ratio.

Why is the real gain smaller than the pressure ratio?

Compressing air heats it, which lowers its density. Turbo lag, exhaust back pressure and the efficiency of the intercooler and the compressor all reduce the gain, so the model applies an efficiency factor.

Is more boost always better?

No. Higher boost raises cylinder pressure and heat, so it increases the risk of knock and mechanical failure. Compression ratio, fuel octane, tuning and the strength of the engine set the limit.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.