Skip to content
Omnikalc

Insertion loss calculator: how much power does a component take away?

Enter the power at the load with and without a component to get its insertion loss in decibels, the share of power transmitted and the total loss in a chain.

Updated on
Your inputs
mW

Value out of range

mW

Value out of range

dB

Value out of range

Results

Insertion loss of the device

2.007 dB

3 dB or less: at least half of the power gets through
Share of the power transmitted
63.00 %
Share of the power lost
37.00 %
Total loss with the extra component
3.507 dB
Power at the load with both components
4.460 mW

Every cable, connector and filter takes a bit of the signal. The insertion loss calculator takes the power at the load without and with a component and gives the insertion loss in decibels, the share of the power transmitted and lost, and the total loss and the power left once another component is added in series.

How the calculation works

  • Measure the power reaching the load without the device, such as a filter, cable, connector or attenuator, and then with the device inserted. Use the same unit for both.
  • The insertion loss is the ratio of the two powers in decibels: IL = 10 × log₁₀(P without ÷ P with).
  • A positive value means a loss. A loss of 3 dB means half of the power is lost, and 10 dB means that 90 percent is lost.
  • Decibel losses of components in series simply add. Enter the loss of a second component to see the total loss and the power left at the load.

Example

A load receives 10 mW without a filter and 6.3 mW with it. The insertion loss is 10 × log₁₀(10 ÷ 6.3) = 2.007 dB, so 63 % of the power is transmitted and 37 % is lost. Adding a connector with a 1.5 dB loss gives a total of 3.507 dB, and the load receives 6.3 × 10^(−0.15) = 4.46 mW.

Why it matters

Radio, audio, fiber-optic and test engineers use insertion loss to budget signal levels and to compare components. Working in decibels makes it simple to add the losses of a chain.

Good to know

The calculation compares powers measured under the same conditions. It does not tell whether the loss comes from absorption or reflection. Frequency matters, because the loss of most components changes with frequency, so measure it at the frequency you use.

The dBm converter converts between milliwatts and decibel-milliwatts, and the free space path loss calculator adds the loss from distance.

Frequently asked questions

What is insertion loss?

It is the loss of signal power caused by inserting a device in a transmission path, such as a filter, a connector, a cable or a switch. It is measured in decibels and compares the power that reaches the load with and without the device.

How do decibels relate to power ratios?

Every 3 dB of loss halves the power and every 10 dB divides it by ten. A loss of 20 dB leaves 1 percent and 30 dB leaves 0.1 percent. Because decibels are logarithmic, the losses of components in series add up.

How is insertion loss different from return loss?

Insertion loss is about the power that is lost on the way through the device, mainly absorbed or radiated. Return loss is about the power reflected back toward the source because of an impedance mismatch. A device can have low insertion loss and still reflect a lot.

Can the insertion loss be negative?

A negative value would mean a gain, as in an amplifier. For a passive device, a negative value usually points to a measurement error or an effect of mismatch between the measurements with and without the device.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.