Skip to content
Omnikalc

Mutation-selection balance calculator: how common is a harmful allele at equilibrium?

Enter the mutation rate, the selection coefficient and the dominance coefficient to get the equilibrium frequency of a harmful allele and the carrier frequency.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Results

Equilibrium frequency of a harmful recessive allele (√(μ ÷ s))

0.00316

Carrier frequency (2q)
0.00632
Carriers: 1 in
158
Affected frequency (μ ÷ s)
0.0000100
Equilibrium frequency of a partly dominant harmful allele (μ ÷ (h × s))
0.000500

Harmful alleles persist because mutation keeps creating them. The mutation-selection balance calculator takes the mutation rate, the selection coefficient and the dominance coefficient, and gives the equilibrium frequency of a harmful recessive allele, the carrier frequency, the affected frequency and the equilibrium frequency of a partly dominant allele.

How the calculation works

  • New harmful alleles arise by mutation at a rate μ per gamete per generation, and selection removes them at a rate that depends on how harmful they are. At equilibrium the two balance.
  • For a recessive harmful allele, only the homozygotes q² are selected against. Equilibrium gives q = √(μ ÷ s), and the affected frequency is q² = μ ÷ s.
  • Almost all copies are in carriers, so the carrier frequency is about 2q. For a partly dominant allele, selection acts on the heterozygotes too, and q = μ ÷ (h × s).
  • A fully harmful recessive has s = 1, and a milder one has a smaller s, which lets the allele reach a higher frequency.

Example

A recessive lethal condition (s = 1) arises at a rate of 10 per million gametes. The equilibrium frequency is √(0.00001) = 0.00316, so about 0.63 % of people are carriers, or 1 in 158, and 1 in 100,000 is affected. If the allele were partly dominant with h = 0.02, the equilibrium frequency would fall to 0.00001 ÷ 0.02 = 0.0005.

Why it matters

Population geneticists use this model to explain why genetic diseases do not disappear, and to estimate mutation rates from the frequency of disease. It is a staple of genetics and evolution courses.

Good to know

The model assumes a very large population, random mating, a constant mutation rate and no back mutation, migration or heterozygote advantage. For diseases with later onset or reduced fitness effects, the selection coefficient is hard to define. Use the results as an order of magnitude.

The Hardy-Weinberg calculator gives genotype frequencies from an allele frequency, and the mutation rate calculator estimates how often new mutations arise.

Frequently asked questions

What is mutation-selection balance?

It is the equilibrium that results when new copies of a harmful allele are created by mutation at the same rate as selection removes them. The allele stays at a low steady frequency in the population rather than disappearing, which explains why genetic diseases persist.

Why do recessive alleles reach higher frequencies than dominant ones?

A harmful dominant allele is exposed to selection in every carrier, so it is removed quickly. A recessive allele is hidden in heterozygotes and is selected against only in the rare homozygotes, so many more copies survive at equilibrium for the same mutation rate.

How good is this model for real diseases?

It fits some conditions well, but many diseases also persist because heterozygotes have an advantage, as with sickle cell and malaria, or because of founder effects and drift. Mutation rates also differ widely between genes. The model gives a baseline to compare with.

What mutation rates are typical?

Per-gene rates in humans are commonly in the range of 1 to 100 new mutations per million gametes per generation, depending on the gene size and the type of mutation. This calculator takes the rate per million, which is easier to enter.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.