Skip to content
Omnikalc

How fast is the air or water flowing?

Enter the dynamic pressure measured by a Pitot tube and the fluid density: get the flow speed in m/s, km/h, mph and knots, plus the Mach number.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Results

Flow speed

20.20 m/s

Speed in miles per hour

45.2 mph

Speed in kilometres per hour
72.7 km/h
Speed in knots
39.3 kt
Mach number (air at 15 °C)
0.0594
Within the range where the incompressible formula is accurate

A Pitot tube measures the speed of a fluid by comparing two pressures: the total pressure at the tip of a tube that faces the flow, and the static pressure beside it. The difference is the dynamic pressure, and the speed follows from it. Airplanes, wind tunnels, ventilation ducts, drones and boats use this simple and reliable principle. This calculator turns a pressure difference and a density into a speed.

How the calculation works

  • Dynamic pressure = total pressure − static pressure = ½ × ρ × v²
  • Speed v = Cp × √(2 × dynamic pressure ÷ density)
  • Conversions: 1 m/s = 3.6 km/h = 2.237 mph = 1.944 knots
  • Mach number = speed ÷ 340.29 m/s, for air at 15 °C

Example

A probe in a ventilation duct reads a dynamic pressure of 250 Pa in air of density 1.225 kg/m³. The speed is √(2 × 250 ÷ 1.225) = 20.2 m/s, which is 72.7 km/h, 45.2 mph or 39.3 knots. The Mach number is 0.059, well inside the range where the incompressible formula is accurate.

Where it is used

Aircraft airspeed indicators, ventilation balancing, wind tunnels, race cars and drones depend on Pitot probes. In HVAC work, technicians measure the pressure with a manometer in inches or millimetres of water and convert it to a speed, then multiply by the duct area for the airflow. Boats use a similar tube to measure the speed through water.

Good to know

The probe must point straight into the flow, away from walls and turbulence. Ice, dirt or insects can block the ports and give false readings, which is why aircraft probes are heated. Density changes with temperature, pressure and humidity, so use the real value for accurate work. Above Mach 0.3 a compressibility correction applies, and at supersonic speeds the shock wave in front of the tube changes the pressure relation altogether.

For the pressure and speed of a flow in a pipe, use the Bernoulli calculator and the Venturi meter calculator. The pipe flow velocity calculator converts a speed into a flow rate, and the Mach number calculator relates a speed to the speed of sound.

Frequently asked questions

How does a Pitot tube measure speed?

A tube facing the flow measures the total pressure, and a side port measures the static pressure. Their difference is the dynamic pressure ½ × density × speed², so the speed is √(2 × difference ÷ density).

Why does the density matter?

For the same pressure difference, a denser fluid flows more slowly. Air density falls with altitude and temperature, so an airspeed indicator reads the equivalent speed at sea level, not the true speed.

What is the limit of this formula?

It assumes an incompressible flow, which holds for air up to about Mach 0.3, around 100 m/s. At higher speeds a compressibility correction is needed.

Can I use it for water?

Yes. Enter a density of about 998 kg/m³. A Pitot tube is used to measure the speed of boats, pipes and rivers.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.