Skip to content
Omnikalc

Seafloor age calculator: how old is the ocean crust and how deep is the ocean at a given distance from the ridge?

Enter the distance from a mid-ocean ridge and its spreading rate to get the age of the seafloor, the expected depth, the lithosphere thickness and the heat flow.

Updated on
Your inputs
km

Value out of range

mm/yr

Value out of range

Results

Age of the seafloor

33.3 million years

Expected ocean depth

4,518 m

Thickness of the cooled lithosphere
75 km
Heat flow through the seafloor
82 mW/m²
Speed of each plate away from the ridge
30.0 mm/yr
Distance from the ridge where the seafloor is 100 million years old
3,000 km

New oceanic crust forms at mid-ocean ridges and moves away on both sides like two conveyor belts. If you know how fast the plates separate, the age of the seafloor follows from the distance to the ridge. As the crust ages, it cools, contracts and sinks, so the depth of the ocean increases in a predictable way. This calculator gives the age, the expected depth, the thickness of the lithosphere and the heat flow for a given distance and spreading rate.

How the calculation works

  • Half-rate (speed of each plate) = full spreading rate ÷ 2; 1 mm per year equals 1 km per million years
  • Age (million years) = distance (km) ÷ half-rate (mm/yr)
  • Depth for age t ≤ 20 million years: 2500 + 350 √t metres
  • Depth for older crust: 6400 − 3200 e^(−t ÷ 62.8) metres
  • Lithosphere thickness ≈ 13 √t km, limited to about 125 km
  • Heat flow ≈ 473 ÷ √t mW/m², levelling off near 45 mW/m²

Example

A site 1000 km from a ridge that spreads at 60 mm per year sits on a plate moving at 30.0 mm per year away from the axis. The crust there is 33.3 million years old. The expected depth is 4,518 m, the lithosphere is 75 km thick and the heat flow is 82 mW/m². To reach crust 100 million years old, you would have to go 3,000 km from the ridge.

Why it matters

The relation between age and depth was one of the key proofs of plate tectonics. Ridges are shallow, near 2,500 m, and the ocean floor deepens with the square root of age until it flattens at about 6,000 m for old crust. Magnetic stripes and drilling ages confirm the age picture. Knowing the age helps to estimate heat flow for geothermal studies, the thickness of the plate for subduction models and the depth for cable and survey planning.

Good to know

The formula assumes a constant spreading rate, which may vary over millions of years, and a symmetric ridge, though many ridges spread asymmetrically. The depth law is an average: hot spots, seamounts and thick sediments change local depth. Near continents, sediments from rivers raise the heat-flow reading and bury the crust. The numbers come from empirical fits to the ocean floor and are best for ages below 100 million years.

In practice

Compare the Atlantic (slow, about 25 mm per year) with the Pacific (fast, up to 150 mm per year): the same distance gives very different ages. Use the age to date crust or to check a map of ocean ages. This tool is educational.

Frequently asked questions

How is seafloor age computed from the spreading rate?

Divide the distance to the ridge by the speed of one plate, which is half the full spreading rate. With 60 mm per year in total, each plate moves at 30 mm per year, so 1000 km corresponds to 33.3 million years.

Why does the ocean deepen away from the ridge?

New crust is hot and buoyant. As it moves away, it cools and contracts, so it sinks. The depth follows the square root of age for young crust.

What is the oldest seafloor?

The oldest ocean crust is about 180 million years old, in the western Pacific and the Mediterranean region. Older crust has been destroyed by subduction.

Does the calculator use full or half rates?

You enter the full rate, the speed of separation of the two plates. The calculator uses half of it for the age on one side.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.