Skip to content
Omnikalc

Tire contact patch calculator

Enter the load on one tire, the inflation pressure and the tire width to get the area of the contact patch, its length, the total footprint of the four tires and a comparison with a sheet of paper.

Updated on
Your inputs
lb

Value out of range

psi

Value out of range

in

Value out of range

%

Value out of range

Results

Contact patch area of one tire

28.1 in²

Length of the patch

4.4 in

Total footprint of four tires

113 in²

Width of the patch
6.4 in
Equivalent in sheets of paper (letter or A4)
1.2
Average pressure on the road
32.0 psi

The tire contact patch calculator gives the area of the contact patch of a tire from its load and inflation pressure, its length and width, the total footprint of the four tires and an equivalent in sheets of paper, to show how little rubber touches the road.

How the calculation works

  • Enter the load on one tire and the inflation pressure.
  • Enter the tire section width and the share of it in contact with the road.
  • Read the patch area, its length and the total footprint.

Example

A tire carrying 900 lb at 32 psi has a contact patch of 28.1 in². With a section width of 7.5 in and a contact width of 6.4 in, the patch is 4.4 in long. The four tires together touch the road over 113 in², about 1.2 sheets of paper.

Why it matters

The calculator helps drivers, mechanics, off-road enthusiasts, cyclists and students who want to see the effect of the inflation pressure and the load on the size of the footprint, and to understand why pressure matters for grip, wear and fuel economy.

Good to know

Use the load on the tire from a corner weight measurement if you have it, or a quarter of the vehicle weight as a starting point. Use the pressure of the tire when hot if you want to know the working value. The simple formula ignores the stiffness of the sidewall and the tread, which add a share of load capacity, so the true patch is slightly smaller. The contact width depends on the tire profile, and 85 percent is a typical value for a road tire. The calculation applies to cars, bikes and trailers alike.

The tire pressure temperature calculator shows how pressure changes with the weather, the tire size calculator converts tire sizes, the tongue weight calculator sets a hitch load and the corner weights calculator gives the load on each tire.

Frequently asked questions

How is the size of the contact patch calculated?

The simplest estimate divides the load carried by the tire by its inflation pressure: area = load / pressure. A tire carrying 900 pounds at 32 psi has a patch of 28 square inches. The result is an approximation, because the stiff sidewall also carries a part of the load, but it is correct within 10 to 20 percent for most tires.

Does a wider tire have a larger contact patch?

Not for the same load and pressure. The area depends on the load and the pressure only, so a wider tire gives a shorter and wider patch of about the same size. The difference is the shape: a wide tire has a short patch with better lateral stability and less heating, a narrow tire a long and narrow one that cuts through water or snow better.

What happens if I lower the pressure?

A lower pressure gives a larger patch, which can improve traction on sand, snow or mud, and the ride is softer. On a road, too low a pressure overheats the tire, increases wear on the edges and the rolling resistance, and makes the steering vague. Use the pressure recommended on the placard of your vehicle and adapt it to the load.

Why is the patch so small?

The area of four contact patches is surprisingly small, close to one or two sheets of paper in total, which shows how little rubber holds a vehicle to the road. The grip depends on this small area, so the condition of the tires and their pressure matter a great deal in braking and cornering.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.