Skip to content
Omnikalc

Van Deemter equation calculator

Enter the A, B and C terms, the actual linear velocity and the column length to get the plate height and plates at your flow, the optimum velocity, the minimum plate height and the efficiency lost.

Updated on
Your inputs
µm

Value out of range

µm·mm/s

Value out of range

µm·s/mm

Value out of range

mm/s

Value out of range

cm

Value out of range

Results

Plate height at this velocity

18.33 µm

Plates at this velocity
8,182
Optimum linear velocity
3.16 mm/s
Minimum plate height
14.65 µm
Plates at the optimum
10,240
Efficiency lost at this velocity
20.1 %
Far from the optimum velocity

The van Deemter equation calculator gives the plate height, the number of plates, the optimum linear velocity, the minimum plate height and the efficiency lost at a chosen flow, from the A, B and C terms of a column.

How the calculation works

  • Enter the A, B and C terms.
  • Enter the linear velocity and the column length.
  • The calculator gives the plate height, the plates, the optimum velocity, the minimum height, the plates at the optimum and the efficiency lost.

Example

With A = 2 µm, B = 20 µm·mm/s and C = 2 µm·s/mm, the plate height at 1.5 mm/s is 2 + 20 / 1.5 + 2 × 1.5 = 18.33 µm, which gives 8,182 plates on 15 cm. The optimum is √(20 / 2) = 3.16 mm/s, with a plate height of 14.65 µm and 10,240 plates, so the chosen flow loses 20.1 % of the efficiency.

Why it matters

The calculator helps chromatography students, analysts and method developers who choose a flow rate, compare column technologies or study how efficiency changes with the speed.

Good to know

The A, B and C terms come from experiments: measure the plate height at several flow rates and fit the equation. The units must be consistent, so here the velocity is in millimeters per second and the heights in micrometers. In gas chromatography the optimum velocity is higher and the curve is flatter with a light carrier gas such as hydrogen, which is why it is used for fast analyses. The model is an empirical simplification, and in liquid chromatography other models such as Knox or Giddings may fit better. Practical methods often run above the optimum velocity to save time, accepting a small loss of efficiency.

The plate number calculator computes plates from a peak, the chromatographic resolution calculator judges a separation, the Rf value calculator covers thin layer chromatography and the Reynolds number calculator characterizes flow.

Frequently asked questions

What does the van Deemter equation say?

The plate height H depends on the linear velocity u of the mobile phase: H = A + B / u + C × u. The A term is the multiple paths between the particles, B the diffusion along the column, which matters at low flow, and C the slow mass transfer between phases, which matters at high flow.

How is the optimum found?

The curve has a minimum where the derivative is zero: u_opt = √(B / C), and H_min = A + 2 √(B C). Running at the optimum gives the most plates for a given column, but it also gives the longest analysis, so a higher velocity is often used.

Why do small particles help?

Smaller particles reduce the A and C terms, because the diffusion distances are shorter, so the curve gets flatter and the minimum lower. This is why columns packed with sub-2-micrometer particles work well at high flow, at the price of high pressure.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.