Skip to content
Omnikalc

Chromatography plate number calculator

Enter the retention time, the peak width, the column length and the particle size to get the number of theoretical plates, the plate height, the plates per meter and the reduced plate height of a column.

Updated on
Your inputs
min

Value out of range

min

Value out of range

cm

Value out of range

µm

Value out of range

Results

Theoretical plates

6,922

Plate height (HETP)
21.67 µm
Plates per meter
46,148
Reduced plate height
4.33
Acceptable column efficiency
Peak standard deviation in time
0.0625 min

The chromatography plate number calculator gives the number of theoretical plates, the plate height, the plates per meter and the reduced plate height of a chromatographic column from the retention time and the peak width.

How the calculation works

  • Enter the retention time and the peak width, and pick how the width was measured.
  • Enter the column length and the particle diameter.
  • The calculator gives the plates, the plate height, the plates per meter, the reduced plate height and the peak standard deviation.

Example

A peak with a retention time of 5.2 min and a base width of 0.25 min gives N = 16 × (5.2 / 0.25)² = 6,922 plates. On a 15 cm column, the plate height is 21.67 µm, or 46,148 plates per meter. For 5 µm particles, the reduced plate height is 4.33, a good value.

Why it matters

The calculator helps chemistry students, laboratory technicians and analysts who check the efficiency of HPLC or gas chromatography columns and follow their aging.

Good to know

The plate number depends on the compound, the flow rate, the temperature and the way the width is measured, so compare columns under the same conditions. Software often computes the number from the half-height width or from the peak moments, and the values differ slightly for asymmetric peaks. Extra-column volume in the tubing and the detector widens the peaks and lowers the apparent plate count, especially for short columns and early peaks. A drop of the plate number over time shows column aging or contamination. Use a well-retained, symmetric peak for the test, not one near the void time.

The Rf value calculator covers thin layer chromatography, the chromatographic resolution calculator uses the plates to judge a separation, the van Deemter calculator explains the effect of the flow and the standard deviation calculator describes peak spread.

Frequently asked questions

What is a theoretical plate?

The plate model pictures a column as a series of small steps in each of which the analyte comes to equilibrium between the mobile and the stationary phases. A larger number of plates means narrower peaks for the same retention time, so better separations.

Which formula is used?

With the width at the base, N = 16 (tR / w)². With the width at half height, N = 5.54 (tR / w½)². Both come from the Gaussian shape of the peak, and give the same result for a symmetric peak. Use the same units for the retention time and the width.

What is the reduced plate height?

It is the plate height divided by the particle diameter, which allows columns with different particles to be compared. A well-packed column gives a value of about 2 to 3. Much higher values point to a poor packing, a dead volume or a degraded column.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.