Skip to content
Omnikalc

Water potential calculator: will water enter or leave the plant cell?

Enter the solute concentration, temperature and turgor pressure of a cell and the water potential of its surroundings to find the direction of water movement.

Updated on
Your inputs
mol/L

Value out of range

Value out of range

°C

Value out of range

MPa

Value out of range

MPa

Value out of range

Results

Water potential of the cell Ψ = Ψs + Ψp

-0.3436 MPa

Solute (osmotic) potential Ψs
-0.7436 MPa
Difference between the cell and its surroundings
0.1564 MPa
Water leaves the cell: the surroundings have the lower water potential

Water in a plant cell moves according to the difference in its potential. The water potential calculator takes the solute concentration, the ionization constant, the temperature and the turgor pressure of the cell, and gives the solute potential, the cell’s water potential and the difference from its surroundings, with the direction of water movement.

How the calculation works

  • Enter the solute concentration inside the cell, the ionization constant i, the temperature and the pressure potential (turgor pressure) of the cell.
  • The solute potential is Ψs = −i × C × R × T, with R = 0.008314 L·MPa/(mol·K) and T in kelvin. It is always zero or negative.
  • The water potential of the cell is Ψ = Ψs + Ψp.
  • Enter the water potential of the surroundings to compare. Water moves from the region of higher water potential to the one with the lower water potential.

Example

A cell contains 0.3 mol/L of sucrose (i = 1) at 25 °C, with a turgor pressure of 0.4 MPa. The solute potential is −1 × 0.3 × 0.008314 × 298.15 = −0.7437 MPa, so the water potential of the cell is −0.3437 MPa. In a solution at −0.5 MPa, the cell has the higher potential, so water leaves the cell.

Why it matters

Plant biology and physiology courses use water potential to explain osmosis, wilting, root uptake and the movement of water through plants. The calculator makes it easy to try different solutions and see the direction of flow.

Good to know

The van’t Hoff equation assumes an ideal dilute solution, and concentrated solutions deviate from it. The model also treats the cell as a single compartment. Real tissues have walls, vacuoles and membranes that complicate the picture, so use the results as a guide.

The osmotic pressure calculator uses the same van’t Hoff relation, and the molarity calculator helps you prepare the solution.

Frequently asked questions

What is water potential?

It is a measure of the free energy of water in a system, expressed as a pressure in megapascals. Pure water at standard conditions has a water potential of zero, and solutes or tension make it more negative. Water always moves toward the region with the lower water potential.

What is the difference between solute potential and pressure potential?

The solute potential, or osmotic potential, comes from dissolved substances and is negative. The pressure potential is the physical pressure on the water. Inside a turgid plant cell it is positive because the cell wall pushes back, while in the xylem under tension it is negative.

What does the ionization constant i do?

It counts how many particles each dissolved unit gives. Sucrose does not dissociate, so i is 1. Sodium chloride gives two ions, so i is close to 2, although in practice it is a little lower at higher concentrations.

What happens when the cell loses water?

As water leaves, the cell shrinks and the turgor pressure falls, and the solutes become more concentrated. If the pressure potential reaches zero, the cell is at incipient plasmolysis, and further loss makes the membrane pull away from the wall.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.