Skip to content
Omnikalc

Wing loading calculator: stall speed and power loading

Enter the weight, wing area, maximum lift coefficient and engine power to get the wing loading, the stall speed and the power loading of an aircraft.

Updated on
Your inputs
lb

Value out of range

ft²

Value out of range

Value out of range

hp

Value out of range

Results

Wing loading

14.7 lb/ft²

Low wing loading: gentle stall, short takeoff and good climb, but a bumpy ride in turbulence
Wing loading in metric units
71.6 kg/m²
Stall speed at sea level
52 knots
Stall speed in miles per hour
60 mph
Power loading
14.2 lb/hp

Wing loading is the weight of an aircraft divided by the area of its wings. It tells you how fast the wing must go to hold the aircraft up, and so it sets the stall speed, the takeoff and landing distances and how the aircraft rides in gusts. This calculator gives the wing loading, the stall speed at sea level and the power loading of an aircraft, from its weight, wing area, maximum lift coefficient and engine power.

How the calculation works

  • Wing loading = weight ÷ wing area
  • Stall speed V = √(2 × weight ÷ (air density × wing area × CLmax)), with an air density of 0.002377 slug/ft³ at sea level
  • Power loading = weight ÷ engine power

CLmax is the highest lift coefficient the wing can reach before it stalls: about 1.2 to 1.6 for a typical light aircraft, higher with flaps down.

Example

A light single-engine aircraft of 2,550 lb with 174 ft² of wing, a CLmax of 1.6 and 180 hp. The wing loading is 14.7 lb/ft², or 71.6 kg/m². The stall speed is 52 knots (60 mph) and the power loading is 14.2 lb/hp.

Why it matters

A pilot or builder compares aircraft by wing loading to understand how they will behave. A lightly loaded wing climbs well and lands slowly but bounces in turbulence. A heavily loaded one cruises faster and rides smoothly but has to land fast on a long runway. Loading also rises as passengers and fuel are added, and stall speed rises with it, by about half the percentage increase in weight.

Good to know

The stall speed scales with the square root of the density, so it is higher on a hot day or at a high-altitude airport. Real aircraft publish stall speeds measured in flight, and this estimate is a way to understand them, not a flight planning tool. Load factor in a turn raises the stall speed by the square root of the load factor. This tool is for education and must not be used for flight planning.

The thrust-to-weight calculator compares engine force and weight, the air density calculator gives the density at altitude, and the drone flight time calculator estimates battery endurance.

Frequently asked questions

What is wing loading?

Wing loading is the weight of the aircraft divided by its wing area, in pounds per square foot or kilograms per square meter. It describes how hard each unit of wing has to work to keep the aircraft in the air.

What does a high wing loading mean?

A high wing loading gives a higher stall and landing speed, a longer takeoff run and a wider turn, but a smoother ride in turbulence and better speed. Fighter jets and airliners have much higher loading than gliders and light planes.

How is stall speed estimated?

At the stall, lift equals weight: W = ½ ρ V² S CLmax. Solving for V gives the stall speed from the wing loading and the maximum lift coefficient. Flaps raise CLmax and lower the stall speed.

What is power loading?

Power loading is weight divided by engine power. A lower number means more power for each pound, and so better climb and takeoff performance.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.