The masonry control joint calculator gives the maximum spacing of the control joints, the number of joints, the even spacing and the length to height ratio of the panels, from the length and the height of the wall and the type of masonry.
How the calculation works
- Enter the length and the height of the wall.
- Choose the type of masonry.
- The calculator finds the maximum spacing of the control joints, the number of joints, the even spacing and the length to height ratio of the panels.
Example
A concrete masonry wall of 80 ft by 10 ft, with no joint reinforcement, has a maximum spacing of the smaller of 1.5 × 10 = 15 ft and 25 ft, that is 15 ft. The wall is cut in 80 / 15 = 5.3, rounded up to 6 panels, so it needs 5 joints at an even spacing of 13.33 ft. Each panel has a length to height ratio of 1.33.
Why it matters
The calculator helps masons, builders, estimators, designers and homeowners to plan the joints of a block or brick wall, to count the sealant and the backer rod before the work starts, and to avoid the cracks that appear in a long wall without joints.
Good to know
Draw the joints on the elevation of the wall before you start, and align them with the joints of the foundation and with the edges of the openings. Use special control joint units or a continuous strip of building paper, and seal the face with a flexible sealant over a backer rod. Never fill a joint with mortar. Keep the joints out of the load path of the lintels, and check the position of the horizontal reinforcement.
Related tools
The bricks calculator gives the number of bricks for a wall, the masonry lintel load calculator gives the load on a lintel, the masonry wall axial capacity calculator gives the compression capacity of a wall and the concrete block fill calculator gives the grout for the cells.