Skip to content
Omnikalc

Parking garage ramp slope and length calculator

Enter the floor to floor height, the slope, the transition length and the width to get the length of a parking garage ramp with its transitions, its area and the run per foot of rise.

Updated on
Your inputs
ft

Value out of range

%

Value out of range

ft

Value out of range

ft

Value out of range

Value out of range

Results

Length of the ramp with the two transitions

169.5 ft

Length at the full slope
153.5 ft
Area of one ramp
2,034 ft²
Length of all the ramps
678 ft
Run for one foot of rise
15.4 ft
Gentle enough to park on

The parking garage ramp calculator gives the length of a ramp between two floors from the floor to floor height and the slope, with the transitions at the top and the bottom, the area and the run per foot of rise.

How the calculation works

  • Enter the floor to floor height, the slope of the ramp, the length of each transition and the width of the ramp.
  • Enter the number of ramps that a vehicle climbs from the entrance to the top level.
  • The calculator gives the length at full slope, the length with the two transitions, the area, the total length and the run per foot of rise.

Example

The floors are 10.5 ft apart and the ramp has a slope of 6.5 %, with a transition of 8 ft at each end at half the slope (3.25 %). The two transitions climb 2 × 8 × 0.0325 = 0.52 ft, so the full slope must climb 9.98 ft over 9.98 / 0.065 = 153.5 ft. The ramp is 169.5 ft long and covers 2,034 ft² at a width of 12 ft. Four ramps add up to 678 ft, and the ramp needs 15.4 ft of run per foot of rise.

Why it matters

The calculator helps architects, parking designers, engineers and developers to check how much floor area a ramp takes, to compare slopes and to test the layout of a garage at the start of a project.

Good to know

Take the floor to floor height from the section, including the thickness of the slab and the topping, not the clear height. Do not let the ramp run on the same line as the parking aisle if it is steep, since a car that parks on it must be on a gentle slope. Check the bottoming out of the design car with the transitions shown on a section, and look at the clearance below the slab above. A ramp in an exterior garage may need a lower slope for ice. A shorter ramp saves area but the comfort of the drivers and the risk of damage are the price.

The turning radius calculator gives the turning circle of a car, the parking lot layout calculator lays out stalls and aisles, the vertical curve calculator designs a crest or a sag and the loading dock calculator gives the number of dock doors.

Frequently asked questions

Why use transitions?

Where a ramp meets a flat floor, a car with a long wheelbase or a low front can scrape the pavement or the bumper, because the slope changes at once. A transition with a slope of half the ramp, over a few feet at the bottom and the top, makes the change gradual and avoids the bottoming out, which the car cannot recover from.

What slope should I use?

A ramp that cars park on is usually flat, about 5 % or less, and many codes cap a parking ramp near 6.7 % (1 in 15). A ramp used only for driving is steeper, often 10 % to 12.5 % and in some places up to 15 % or 20 %. The code, the owner and the comfort of the drivers decide, and the calculator only does the geometry.

How is the length found?

The transitions climb a part of the height, each at half of the ramp slope, so the rise at the full slope is the floor to floor height minus the length of the transitions times the slope. The length at full slope is that rise divided by the slope, and the plan length is that length plus the two transitions.

What does the calculator leave out?

The calculator leaves out the curves of a helical ramp, the clear height, the width for the turn, the cross slope for drainage, the curbs and the sight lines. It treats a straight ramp between two floors. A curved ramp needs a larger width and the check of the swept path of a car.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.