Skip to content
Omnikalc

What rough opening does a pocket door need?

Enter the door width and height, the width and header allowances, the framing on each side and the space lost to the stop and pull: get the rough opening width and height, the pocket length, the wall length to keep free and the clear passage.

Updated on
Your inputs
in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Results

Rough opening width

61.0 in

Rough opening height

84.5 in

Pocket length
30 in
Wall to keep free of pipes and wiring
64 in
Clear passage
29 in
Always follow the frame kit's instructions, since rough openings vary by brand; choose a kit with a sturdy track and steel-reinforced split studs, and never put a pocket door in a load-bearing wall without a proper header

A pocket door slides into the wall instead of swinging into the room, which frees the floor space a hinged door needs. It is ideal for small bathrooms, closets and laundry rooms. But the wall must have room for the door to disappear into, and the opening has to be framed for the pocket kit. This calculator works out the rough opening, the pocket and the clear passage.

How the calculation works

  • Rough opening width = 2 × door width + width allowance
  • Rough opening height = door height + header allowance for the track
  • Pocket length = door width
  • Wall to keep free = rough opening + framing on each side
  • Clear passage = door width − the width lost to the stop and pull

A 30 × 80 in pocket door needs a rough opening about 61 in wide and 84.5 in high, with 1 in of width allowance and 4.5 in for the track. The pocket is 30 in long, and about 64 in of wall must be free of pipes, ducts and wiring. Because the door stops a little short of fully disappearing, the clear passage is about 29 in.

Standard doors

Door width Rough opening (typical kit) Typical use
24 in about 49 in closet, half bath
28 in about 57 in bathroom, laundry
30 in about 61 in bedroom, bathroom
32 in about 65 in main rooms
36 in about 73 in wheelchair access

These are common values; each frame kit gives its own rough opening, so always check the instructions before framing.

Tips

  • Pick a quality frame kit with a heavy-duty track and steel-reinforced split studs; cheap kits are the main cause of sagging and jamming.
  • The pocket wall cannot hold outlets, switches or plumbing, and hanging heavy things on it can push the door off its track.
  • In a load-bearing wall, the opening needs a proper header sized for the load; ask a builder or engineer.
  • Use short screws when fixing drywall to the pocket, so they cannot scratch the door.
  • Make the door and its trim removable: some kits let you lift the door off the track without opening the wall.
  • Choose a flush pull and an edge pull so the door can be pulled out of the pocket.

Frequently asked questions

What is the rough opening for a 30 in pocket door?

About 61 in wide and 84.5 in high for a 30 × 80 in door; check your frame kit.

How much wall does a pocket door need?

About twice the door width plus framing, about 64 in for a 30 in door, free of pipes and wiring.

Can you put a pocket door in a load-bearing wall?

Only with a properly sized header; ask a builder or engineer.

Can you put outlets in a pocket door wall?

No, the pocket wall cannot hold outlets, switches or plumbing.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.