Skip to content
Omnikalc

Water main disinfection calculator: chlorine needed to disinfect a new water pipe

Enter the diameter, the length, the chlorine dose and the available chlorine of the product to get the volume of the main, the chlorine needed, the weight of product and the contact time.

Updated on
Your inputs
in

Value out of range

ft

Value out of range

Results

Product needed

7.54 lb

Volume of the main
11,750 gal
Chlorine needed (100 %)
4.90 lb
Minimum contact time
24 h

The water main disinfection calculator gives the volume of the main, the chlorine needed, the weight of product and the minimum contact time to disinfect a new water pipe, from the diameter, the length, the chlorine dose and the available chlorine of the product.

How the calculation works

  • Enter the inside diameter and the length of the water main to disinfect.
  • Choose the chlorine dose of the method and the available chlorine of the product used.
  • The calculator finds the volume of the main, the chlorine needed, the weight of product to feed and the minimum contact time.

Example

A main of 12 in and 2,000 ft has a volume of π/4 × 1² × 2,000 × 7.48 = 11,750 gal. For a dose of 50 mg/L, the chlorine is 11,750 × 8.34 × 50 / 1,000,000 = 4.90 lb. With calcium hypochlorite at 65 %, the product is 4.90 / 0.65 = 7.54 lb. The contact time for this dose is 24 h.

Why it matters

The calculator helps utility contractors, water system operators, inspectors and students to prepare the disinfection of a new water main or a repaired section, to order the right quantity of hypochlorite and to plan the contact time before the test.

Good to know

Keep the pipe clean and covered during the storage and the installation, and flush the main at a velocity of at least 3 ft/s before the disinfection. Add the chlorine slowly at the start of the main, check the residual at the ends, and neutralize the water before the discharge to a storm drain or a stream. Wear the protective equipment for the chlorine, and never mix the hypochlorite with other chemicals. Keep a record of the dose, the residual and the contact time for the health authority.

The pool chlorine calculator handles the chlorine of a pool, the well shock chlorination calculator handles the disinfection of a well, the pipe volume calculator gives the volume of a pipe and the pipeline coverage calculator checks the depth of cover.

Frequently asked questions

Why are new water mains disinfected?

A new water main can be contaminated during the construction by the soil, the water in the trench or the handling of the pipe. Before the main is put in service, it is flushed, disinfected with a strong chlorine solution, held for the contact time, flushed again and tested for bacteria. The procedure follows the standard ANSI/AWWA C651, and the health authority may require the bacteriological results.

What doses and contact times are used?

The continuous-feed method fills the main with water at 25 mg/L of free chlorine and holds it for 24 hours. The slug method passes a slug of 100 mg/L through the main for at least 3 hours, which is used for large mains. The tablet method puts chlorine tablets in the pipe sections during the installation. The residual must be at least 10 mg/L after 24 hours for the continuous-feed method.

How is the quantity of chlorine calculated?

The volume of the main is the area of the section times the length. The pounds of chlorine are the volume in million gallons times 8.34 times the dose in mg/L, and the weight of the product is that quantity divided by the available chlorine fraction. In SI units, a dose of 1 mg/L equals 1 g per cubic meter, so the grams of chlorine are the volume in m³ times the dose.

What are the limits of the calculator?

The calculator gives the chlorine needed to fill the main only. It does not include the water used for the flushing, the neutralization and the disposal of the chlorinated water, which must follow the environmental rules, the chlorine demand of the pipe, the valves and the fittings, or the safety of the workers who handle the hypochlorite. Follow the procedure of the utility and of the AWWA standard.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.