Skip to content
Omnikalc

Leaching requirement calculator

Enter the salinity of the irrigation water, the tolerable soil salinity of the crop and the net water need to get the leaching fraction, the gross irrigation depth and the extra water.

Updated on
Your inputs
dS/m

Value out of range

dS/m

Value out of range

in

Value out of range

Results

Leaching requirement

6.4 %

Gross irrigation depth

25.6 in

Extra water for leaching
1.6 in
Salinity of the drainage water
18.8 dS/m
Feasible (1 if the water is below 5 × ECe)
1

The leaching requirement calculator gives the leaching requirement as a percentage, the gross irrigation depth, the extra water for leaching, the salinity of the drainage water and whether the plan is feasible, from the water and crop salinities.

How the calculation works

  • Enter the electrical conductivity of the irrigation water (ECw) in dS/m.
  • Enter the tolerable soil salinity (ECe) of the crop for the yield you accept.
  • Enter the net irrigation requirement of the crop for the season.

Example

Water of 1.2 dS/m on a crop that tolerates 4 dS/m needs a leaching requirement of 6.4 %. A net requirement of 24 in becomes a gross irrigation of 25.6 in, with 1.6 in of extra water. The drainage water reaches 18.8 dS/m.

Why it matters

The calculator helps farmers, irrigation advisers and students in dry regions, where the irrigation water contains salts, who must plan the extra water to protect the soil and the yield, and who want to decide whether a water source is usable for a given crop.

Good to know

Use the conductivity of the water as measured in the laboratory, and the ECe of the crop for the yield loss that is acceptable, from a salt tolerance table. The formula assumes steady-state conditions, good drainage and no contribution of salts from the soil or from a shallow water table. For high-frequency irrigation and for drip systems, use the specific methods. If ECw is more than 5 times ECe, the formula has no solution and the water cannot be used for this crop without a different management. Always confirm with local guidelines.

The crop water need calculator gives the net requirement, the drip irrigation calculator sizes an emitter system, the reference evapotranspiration calculator estimates the water demand of the atmosphere and the available water capacity calculator describes the soil reservoir.

Frequently asked questions

What is the leaching requirement?

It is the fraction of the irrigation water that must pass through the root zone and drain below it to carry away the salts that the water brings, so that the soil salinity does not exceed what the crop tolerates. Without leaching, the salts accumulate as the plants take up the water and leave the salts behind.

How is it calculated?

The calculator uses the formula of the US Salinity Laboratory for surface irrigation, LR = ECw / (5 ECe − ECw), where ECw is the conductivity of the irrigation water and ECe the conductivity of the saturated soil extract that the crop tolerates. The gross depth is the net requirement divided by (1 − LR).

What is the crop tolerance value?

Each crop has a threshold salinity above which the yield starts to drop, and a slope of loss per unit of extra salinity. Beans are sensitive, with a threshold of about 1 dS/m, corn about 1.7, wheat 6 and barley 8. Use the ECe for the yield that you accept, from a table of salt tolerance of crops.

Can the leaching be done another way?

Yes. Leaching can be done in the irrigation season with the extra water, or in a seasonal leaching event before planting when the rain is not enough. With drip irrigation, the salts accumulate at the edge of the wetted zone, so the formula for surface irrigation can understate the need in the high-frequency irrigation of a drip system.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.