Skip to content
Omnikalc

How big should a bat house be?

Enter the number of roosting chambers, their width and height, the gap between partitions and the board thickness: get a rough capacity, the inside depth and the plywood area to cut.

Updated on
Your inputs

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Results

Rough capacity

144

Plywood to cut

14.0 sq ft

Mount it at least 12 ft high on a pole or building where it gets 6 hours or more of sun, with a roughened landing area below the entrance
Inside depth
1.75 in

A bat house gives bats a warm, dark crevice to roost in during the day, and a colony can eat huge numbers of night-flying insects. Bats are fussy about their roost: narrow chambers, a rough surface to cling to, plenty of sun and a high, open spot. This calculator sizes a multi-chamber bat house, estimates roughly how many bats it can hold and works out the plywood to cut.

How the calculation works

  • Inside depth = chambers × gap + (chambers − 1) × partition thickness
  • Rough capacity = chambers × width × height ÷ 8 sq in, a rough allowance per bat
  • Plywood = back (with a 5 in landing area below the chambers) + front + partitions + two sides + roof with a 2 in overhang

A 2-chamber house 24 in wide with chambers 24 in tall and 3/4 in gaps is about 1.75 in deep inside with 1/4 in partitions. It could roost roughly 144 bats and takes about 14 sq ft of plywood, about half a 4 × 8 ft sheet.

The capacity is only an order of magnitude: real occupancy depends on the species, the climate and how well the house is placed, and many houses take a season or two to be found.

Key dimensions

Feature Common recommendation
Chamber gap 3/4 to 1 in
Chamber height 20 in or more
Width 14 in or more, 24 in is common
Landing area 3 to 6 in below the entrance, roughened
Mounting height 12 ft or more, 15 to 20 ft is better

Taller and wider chambers give bats more choice of temperature as the day warms up.

Building tips

  • Use exterior-grade plywood or rough-sawn wood; never use pressure-treated wood inside the roost.
  • Roughen every inside surface and the landing area with horizontal grooves or plastic mesh stapled flat, so bats can grip.
  • Seal the joints with caulk so the house stays warm, and add a vent slot across the front, a few inches above the bottom.
  • Paint the outside a dark color in cool climates and a medium or light color in hot ones, with exterior water-based paint.

Placement

Bats like heat: aim for 6 hours or more of direct sun, ideally facing south or east. Mount the house on a pole or a building wall, not a tree, where it is clear of branches and away from lights, within reach of water such as a pond or stream. Many bats are protected species, so never disturb an occupied roost.

Frequently asked questions

How many bats can a bat house hold?

Roughly 144 for a 2-chamber house 24 in wide and 24 in tall, though real occupancy varies a lot.

How wide should bat house chambers be?

About 3/4 to 1 in between partitions.

How high should a bat house be mounted?

At least 12 ft, ideally 15 to 20 ft, on a pole or building wall.

How much sun does a bat house need?

6 hours or more of direct sun, ideally facing south or east.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.