Skip to content
Omnikalc

Geometric unsharpness calculator (radiography)

Enter the focal spot size, the source to image distance and the object to image distance to get the geometric unsharpness, the magnification, the size of the object on the image and the largest object to image distance for a target blur.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mm

Value out of range

cm

Value out of range

cm

Value out of range

mm

Value out of range

mm

Value out of range

Results

Geometric unsharpness

0.067 mm

The blur stays within the acceptable limit
Magnification
1.111
Size of the object on the image
22.22 mm
Source to object distance
90.0 cm
Largest object to image distance for the acceptable blur
33.3 cm

The geometric unsharpness calculator gives the focal spot blur, the magnification and the image size of an object in radiography, and the largest object to image distance that keeps the blur under a target value.

How the calculation works

  • Enter the focal spot size and the source to image distance.
  • Enter the object to image distance and the object size.
  • Read the unsharpness, the magnification and the limit distance.

Example

A 0.6 mm focal spot, a source to image distance of 100 cm and an object 10 cm from the receptor give a geometric unsharpness of 0.6 × 10 / 90 = 0.067 mm and a magnification of 1.111. An object of 20 mm appears as 22.22 mm. To keep the blur at 0.3 mm the object must be within 33.3 cm of the receptor.

Why it matters

The calculator helps radiography students and technologists, medical physicists and industrial radiographers who must choose a distance and a focal spot for sharp images.

Good to know

The simple geometry assumes a uniform focal spot and ignores the tilt of the anode, which makes the effective focal spot different across the field. The blur also combines with the detector blur and motion blur, and the total can be found by combining the widths in quadrature. In the same way, a larger focal spot in mammography or fluoroscopy is used with an air gap to avoid the loss of sharpness. The magnification changes the apparent size of structures, so measurements on a radiograph must be corrected using the known magnification. For a sharp image, keep the object near the receptor, use the longest practical distance and the smallest focal spot compatible with the exposure time, and fix the patient to avoid motion.

The MTF calculator describes the total sharpness, the exposure adjustment calculator corrects mAs for distance, the inverse square law calculator shows the intensity change and the skin dose calculator estimates patient dose.

Frequently asked questions

What is geometric unsharpness?

Because the focal spot has a size, the edge of an object is blurred on the image, in a band called the penumbra. The width is Ug = F × OID / (SID − OID), with F the focal spot, OID the object to image distance and SID the source to image distance.

How do I reduce the blur?

Use a smaller focal spot, a longer source to image distance and put the object as close to the receptor as possible. Each choice has a cost: a small focal spot limits the tube current, a longer distance requires more mAs.

Why use magnification radiography?

Magnification shows fine detail, as in mammography or in bone detail, but it increases the blur from the focal spot, so it needs a very small focal spot, often 0.1 to 0.3 mm.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.