Skip to content
Omnikalc

Radiographic exposure adjustment calculator

Enter the mAs, kVp, distance and grid of a technique that works, then the new kVp, distance and grid, to get the mAs that keeps the same receptor exposure using the inverse square law, the grid conversion factor and the 15 percent rule.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mAs

Value out of range

kVp

Value out of range

cm

Value out of range

kVp

Value out of range

cm

Value out of range

Results

New mAs

22.50 mAs

Overall mAs factor
1.125
Factor from the kVp change (15 % rule)
0.500
Factor from the distance change
2.250
Factor from the grid change
1.000
Approximate change in entrance skin dose (dose varies as mAs × kVp² / distance²)
-34 %
The skin dose falls with this technique

The radiographic exposure adjustment calculator gives the new mAs that keeps the same receptor exposure when you change the kVp, the distance or the grid, with the 15 percent rule, the inverse square law and the grid factor.

How the calculation works

  • Enter the mAs, kVp, distance and grid of the original technique.
  • Enter the new kVp, distance and grid.
  • Read the new mAs and the factor from each change.

Example

A technique of 20 mAs at 80 kVp, 100 cm and an 8:1 grid is changed to 92 kVp (15 % more) and 150 cm with the same grid. The kVp factor is 0.500, the distance factor is 2.250, the grid factor is 1.000, so the new technique is 22.50 mAs, an overall factor of 1.125.

Why it matters

The calculator helps radiography students and technologists who must adapt a technique to a different room, a mobile unit, a patient too large for the usual technique or a change of grid.

Good to know

These are rules of thumb, not exact physics. The 15 percent rule changes the contrast and the patient dose, the inverse square law assumes a point source and no air attenuation, and the grid factor depends on the grid, the kVp and the field size. Digital systems tolerate a wider range of exposures, but exposure index values still show whether the receptor received enough signal. Never use a higher mAs just to compensate for a bad technique without thinking about dose, and follow the ALARA principle by using the lowest exposure that gives a diagnostic image. When the original technique was not well adapted, the adjusted one will not be either, so start from a good reference technique.

The tube heat units calculator checks the load of the tube, the skin dose calculator estimates patient dose, the inverse square law calculator shows the distance effect and the contrast to noise calculator links dose to image quality.

Frequently asked questions

What is the 15 percent rule?

Raising the kVp by 15 % roughly doubles the receptor exposure, so the mAs can be halved to get the same exposure; lowering it by 15 % needs twice the mAs. The rule is an approximation that works best in the usual diagnostic range and changes the image contrast.

How does distance change the mAs?

The beam intensity follows the inverse square law, so doubling the distance needs four times the mAs for the same receptor exposure, and halving it needs a quarter.

What is the grid factor?

A grid absorbs scattered radiation but also some of the useful beam, so the mAs must rise: about 2 for a 5:1 grid, 4 for 8:1, 5 for 12:1 and 6 for 16:1. Values vary a little with kVp and the grid, so use your equipment data.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.