Skip to content
Omnikalc

BMEP calculator: how hard does each combustion push on the piston?

Enter the engine power, the displacement, the speed and the cycle to get the brake mean effective pressure in psi and kPa, the torque at that speed and the specific output.

Updated on
Your inputs

Value out of range

Value out of range

rpm

Value out of range

Results

Brake mean effective pressure (BMEP)

135.8 psi

Torque at that speed

315 lb-ft

BMEP in kilopascals
936 kPa
Typical of a naturally aspirated engine
Specific output
52.3 hp per liter

Power and displacement alone do not say how hard an engine is working, since a big engine makes power easily. Brake mean effective pressure, or BMEP, divides the work done by the engine’s displacement. This BMEP calculator takes the power, the displacement, the speed and the cycle to give the BMEP, the torque at that speed and the specific output.

How the calculation works

  • BMEP = 60,000 × cycle factor × power in kW ÷ (displacement in liters × rpm), in kilopascals. The cycle factor is 2 for a four-stroke engine and 1 for a two-stroke.
  • In psi = kPa × 0.145038.
  • Torque = power in kW × 9,549.3 ÷ rpm, in newton-meters, and × 0.737562 for pound-feet.
  • Specific output = power ÷ displacement.

Example

A four-stroke engine of 350 in³ (5.73 L) makes 300 hp (223.7 kW) at 5,000 rpm. BMEP = 60,000 × 2 × 223.7 ÷ (5.73 × 5,000) = 936 kPa, which is 135.8 psi. The torque at that speed is 315 lb-ft and the specific output is 52.3 hp per liter.

Why it matters

BMEP is the standard way to compare engines. It tells an engine designer how close a design is to the limit of cylinder pressure, it lets a tuner see how much a turbocharger adds and it lets a buyer compare a small turbo engine with a large naturally aspirated one on equal terms.

Good to know

BMEP depends on the speed at which the power is measured, and the peak torque speed gives the highest BMEP. Use the power at the brake, not the indicated power, because friction losses are about 10 % or more. For a fair comparison, use the net brake power, measured with the accessories fitted. High BMEP means high loads on bearings and higher heat, so engines with more than 2,000 kPa need strong construction and good cooling.

The horsepower and torque calculator converts between the two, the compression ratio calculator relates to cylinder pressure and the BSFC calculator measures fuel efficiency.

Frequently asked questions

What is BMEP?

Brake mean effective pressure is the average pressure that, acting on the pistons during the power stroke, would produce the engine's measured power. It measures how well an engine uses its displacement, independent of size and speed.

What is a good BMEP?

A naturally aspirated gasoline engine reaches 800 to 1,200 kPa (115 to 175 psi), a naturally aspirated diesel 700 to 900 kPa and turbocharged engines 1,500 to 2,500 kPa. Race engines go beyond these.

Why does BMEP matter?

It is proportional to torque per liter. Two engines of different size can be compared, and it shows how much room an engine has before it reaches its mechanical or thermal limit.

Why does the cycle matter?

A four-stroke engine fires once every two revolutions, a two-stroke every revolution. At the same power, displacement and speed, the four-stroke needs twice the BMEP.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.