Skip to content
Omnikalc

Density altitude calculator: how thin is the air today?

Enter the field elevation, the altimeter setting and the outside temperature to get the pressure altitude, the density altitude and the effect on takeoff.

Updated on
Your inputs

Value out of range

Value out of range

°C

Value out of range

Results

Density altitude

7,958 ft

Performance is much reduced: check the takeoff and climb charts, and consider less load
Pressure altitude
5,000 ft
Standard (ISA) temperature at that altitude
5.1 °C
Estimated increase in takeoff roll
80%
Estimated loss of engine power (unsupercharged)
24%

The altitude on your map is not the altitude your airplane feels. Thin air reduces the lift of the wings, the thrust of the propeller and the power of the engine, and the effect gets stronger as the temperature rises and the pressure falls. The density altitude puts all of this in one number: the altitude at which the standard atmosphere has the density you are flying in.

How the calculation works

  • Pressure altitude = field elevation + (29.92 − altimeter setting in inHg) × 1,000 ft
  • ISA temperature = 15 °C − 1.98 °C per 1,000 ft of pressure altitude
  • Density altitude = pressure altitude + 118.8 ft × (outside temperature − ISA temperature)
  • Takeoff roll increase ≈ 10 % per 1,000 ft of density altitude (rule of thumb)
  • Power loss ≈ 3 % per 1,000 ft for a normally aspirated engine (rule of thumb)

Example

An airport at 5,000 ft with the altimeter at 29.92 inHg and 30 °C: the pressure altitude is 5,000 ft and the ISA temperature 5.1 °C, so the air is 24.9 °C warmer than standard. The density altitude is 7,958 ft, nearly 3,000 ft above the field. Expect a takeoff roll about 80 % longer than at sea level and about 24 % less engine power.

Why it matters

Hot, high and humid is the worst combination for performance, and the accidents it causes happen to pilots who know the numbers but do not apply them. Checking the density altitude before a flight tells you whether to take off early in the morning, to lighten the load or to wait. It also helps to understand why drones and helicopters have lower ceilings in summer.

Good to know

Humidity lowers air density a little more, an effect that is not in this formula. The rules of thumb for roll and power vary by aircraft and are only a first estimate. Turbocharged engines keep their power to a higher altitude. This tool is for education and does not replace the flight manual or the pilot’s judgment.

The true airspeed calculator converts indicated speed using the altitude and the temperature, the air density calculator gives the density directly, and the wing loading calculator shows the stall speed of an aircraft.

Frequently asked questions

What is density altitude?

It is the altitude in the standard atmosphere where the air density would equal the density of the air you are in. On a hot day at a high airport, the air is thin and the density altitude can be thousands of feet above the real elevation.

Why does it matter for pilots?

Thin air gives less engine power, less propeller thrust and less wing lift. The result is a longer takeoff roll, a lower climb rate and a higher true airspeed for the same indicated speed. Many accidents happen on hot, high-altitude takeoffs.

What is pressure altitude?

It is the altitude shown by the altimeter when it is set to the standard pressure of 29.92 inHg (1013.25 hPa). It is the starting point for the density altitude, which then corrects for the temperature.

How accurate is this estimate?

The formula is a standard approximation and is good to about a hundred feet, but the takeoff roll and power loss figures are rules of thumb. Always use the performance charts of your aircraft's flight manual.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.