Skip to content
Omnikalc

Instrumentation amplifier gain calculator

Enter the internal resistor, the gain resistor, the differential signal, the common-mode voltage and the CMRR to get the gain, the output voltage, the error caused by the common-mode voltage and the bandwidth.

Updated on
Your inputs
kΩ

Value out of range

Ω

Value out of range

mV

Value out of range

V

Value out of range

dB

Value out of range

MHz

Value out of range

Results

Gain

51.00

Gain in decibels
34.2 dB
Output voltage for the signal
510.0 mV
Common-mode error referred to the input
10.00 µV
Error as a share of the signal
0.100 %
Negligible error
Small-signal bandwidth
19.6 kHz

The instrumentation amplifier gain calculator gives the gain, the output voltage, the common-mode error and the bandwidth of a three-op-amp instrumentation amplifier.

How the calculation works

  • Enter the internal resistor and the gain resistor.
  • Enter the differential signal, the common-mode voltage and the CMRR.
  • Enter the gain-bandwidth product.
  • The calculator gives the gain, the gain in dB, the output, the common-mode error and the bandwidth.

Example

With 25 kΩ internal resistors and a 1 kΩ gain resistor, the gain is 1 + 2 × 25,000 / 1,000 = 51.00, or 34.2 dB. A 10 mV signal gives 510.0 mV. A 1 V common-mode voltage with 100 dB of CMRR creates an error of 10.00 µV at the input, which is 0.100 % of the signal. With a gain-bandwidth product of 1 MHz, the bandwidth is 19.6 kHz.

Why it matters

The calculator helps electronics students and engineers who read bridge sensors, thermocouples, strain gauges or biomedical signals and need to choose the gain resistor.

Good to know

The CMRR of real amplifiers is specified at a given gain and often rises with gain, so the value used here is conservative at high gain. Resistor mismatch and the source impedance imbalance reduce the effective CMRR. The output must stay within the supply rails, including the amplified common-mode part in some designs, so check the maximum output swing. Noise, offset and drift are amplified with the signal as well, and they limit the smallest signal that can be measured. For a precise gain, use a resistor of low tolerance and low temperature drift, since the internal resistors and the external one drift differently.

The op-amp gain calculator covers inverting and non-inverting stages, the thermal noise calculator estimates noise, the strain gauge calculator converts strain to voltage and the RC filter calculator designs simple filters.

Frequently asked questions

What is the gain formula?

For the classic three-op-amp instrumentation amplifier, the gain is 1 + 2 R / Rg, where R is each of the two feedback resistors in the input stage and Rg the single resistor that sets the gain. Removing Rg gives a gain of 1. Single-chip parts such as the AD620 follow this form with 24.7 kΩ resistors.

What does the CMRR do?

The common-mode rejection ratio tells how much the amplifier suppresses a voltage common to both inputs, such as mains pickup or a sensor bias. A CMRR of 100 dB divides the common-mode voltage by 100,000 before it appears as an error, referred to the input.

Why a bridge sensor needs it?

Bridge sensors such as strain gauges give millivolts riding on a large common-mode voltage, half of the supply. An instrumentation amplifier amplifies only the difference, with high input impedance and a gain set by one resistor.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.