Skip to content
Omnikalc

Thermal noise power calculator

Enter the bandwidth, the temperature, the resistance, the receiver noise figure and the SNR you need to get the thermal noise power in dBm, the noise voltage and the minimum signal a receiver can detect.

Updated on
Your inputs
kHz

Value out of range

°C

Value out of range

Ω

Value out of range

dB

Value out of range

dB

Value out of range

Results

Thermal noise power (kTB)

-113.93 dBm

Noise power density
-173.93 dBm/Hz
Noise power
4.047 fW
Noise voltage across the resistance (rms)
0.900 µV
Receiver noise floor
-108.93 dBm
Minimum detectable signal
-98.93 dBm

The thermal noise power calculator gives the kTB noise power in dBm and watts, the noise voltage of a resistor, the receiver noise floor and the minimum detectable signal.

How the calculation works

  • Enter the bandwidth and the temperature.
  • Enter the resistance, the noise figure and the required SNR.
  • The calculator gives the noise power, the density, the noise voltage, the noise floor and the minimum signal.

Example

In a 1 MHz bandwidth at 20 °C (293.15 K), the noise power is 1.38 × 10⁻²³ × 293.15 × 10⁶ = 4.047 fW, or -113.93 dBm. A 50 Ω resistor shows 0.900 µV rms. A receiver with a 5 dB noise figure has a floor of -108.93 dBm, and a 10 dB SNR needs a signal of at least -98.93 dBm.

Why it matters

The calculator helps radio engineers, amateur radio operators and electronics students who estimate the sensitivity of a receiver, the noise of a sensor circuit or the range of a wireless link.

Good to know

The noise power does not depend on the resistance, only on the temperature and bandwidth, while the noise voltage of a resistor does. A cooler receiver front end has less noise, which is why radio telescopes and satellite receivers use cooled amplifiers. In real circuits other noise sources add to the thermal noise, and the noise figure takes this into account. Use the bandwidth that the receiver really uses, not the one of the signal, if they differ. For wide bandwidths, the white noise assumption holds up to very high frequencies. The values are rms, and the peak value of noise is about three to four times larger.

The noise figure calculator covers the receiver chain, the SNR calculator converts ratios, the dBm converter switches between watts and dBm and the decibel addition calculator adds levels.

Frequently asked questions

What is thermal noise?

It is the random electrical noise caused by the thermal agitation of charge carriers in any conductor above absolute zero. Its available power is k × T × B, where k is the Boltzmann constant, T the temperature in kelvin and B the bandwidth in hertz.

What does −174 dBm/Hz mean?

At the reference temperature of 290 K, the noise density is −174 dBm per hertz. Adding 10 times the logarithm of the bandwidth gives the noise power in dBm: for 1 MHz, −174 + 60 = −114 dBm. Each factor of 10 in bandwidth adds 10 dB.

How is the sensitivity of a receiver found?

Add the noise figure of the receiver to the thermal noise power to get its noise floor, then add the signal-to-noise ratio the demodulator needs. The result is the weakest signal that can be received properly.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.