Skip to content
Omnikalc

MOSFET gate drive power calculator

Enter the total gate charge, the gate-drain charge, the gate voltage, the switching frequency and the gate resistors to get the gate drive power, the average and peak gate currents and the switching time.

Updated on
Your inputs
nC

Value out of range

nC

Value out of range

V

Value out of range

kHz

Value out of range

Ω

Value out of range

Ω

Value out of range

Results

Gate drive power

0.0800 W

Average gate current
8.00 mA
Peak gate current
1.61 A
Within the range of common drivers
Voltage transition time (Miller plateau)
7.4 ns
Power in the external resistor
0.0606 W
Drive current for a given turn-on in 20 ns
2.00 A

The MOSFET gate drive power calculator gives the gate drive power, the average and peak gate currents, the switching time and the power in the gate resistor from the gate charge, the drive voltage and the frequency.

How the calculation works

  • Enter the total gate charge, the gate-drain charge and the drive voltage.
  • Enter the switching frequency and the gate resistances.
  • The calculator gives the power, the average current, the peak current, the switching time, the power in the resistor and the current for a 20 ns turn-on.

Example

A MOSFET with 40 nC of gate charge driven at 10 V and 200 kHz needs 40 × 10⁻⁹ × 10 × 200,000 = 0.0800 W, with an average gate current of 8.00 mA. With 4.7 Ω outside and 1.5 Ω inside, the peak current is 10 / 6.2 = 1.61 A, and the 12 nC Miller charge gives a transition of about 7.4 ns. The external resistor dissipates 0.0606 W.

Why it matters

The calculator helps power electronics designers, hobbyists building converters and motor drives, and students who choose a gate driver and size its supply.

Good to know

The data sheet gives the gate charge for a specific drain voltage and current, and it changes with the operating point, so use the value close to your conditions. A bootstrap supply for a high-side driver must provide this power as well. The gate drive power is small for one transistor, but becomes significant in converters with many parallel devices or at megahertz frequencies. The peak current estimate ignores the driver’s limits and the inductance of the loop. Drivers have a maximum source and sink current, and a driver that is too weak makes the transition slower than expected. Use a separate turn-off path with a diode, if you need a faster turn-off than turn-on.

The MOSFET power loss calculator covers conduction and switching losses, the buck converter calculator and the boost converter calculator size converters and the LED resistor calculator handles current limiting.

Frequently asked questions

How is the gate drive power computed?

Each switching cycle charges and discharges the gate with the total charge Qg through the drive voltage, which takes Qg × Vgs of energy. Multiplied by the frequency, the power is P = Qg × Vgs × f. It is dissipated in the gate resistors and in the driver, not in the MOSFET.

Why does the switching time matter?

While the drain voltage is changing, the gate sits on the Miller plateau and the current flows into the gate-drain charge. The transition time is about Qgd divided by the gate current. A faster transition lowers the switching loss but increases ringing and electromagnetic noise.

How do I choose the gate resistor?

A larger resistor slows the edges, reduces overshoot and noise, and limits the peak current, but raises switching loss. A smaller one switches faster. Designers start from the peak current the driver allows and tune the value on the board by looking at the waveforms.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.