Skip to content
Omnikalc

PLL frequency synthesizer calculator

Enter the reference frequency, the dividers and the loop bandwidth to get the comparison frequency, the VCO and output frequencies, the step size, the in-band phase noise multiplication and the lock time.

Updated on
Your inputs
MHz

Value out of range

Value out of range

Value out of range

Value out of range

kHz

Value out of range

Results

Output frequency

1,000.0000 MHz

Comparison frequency
5.0000 MHz
VCO frequency
2,000.0000 MHz
Frequency step of the output
2.5000 MHz
In-band phase noise multiplication (20 log N/P)
46.0 dB
Approximate lock time
6.4 µs
Comparison frequency over loop bandwidth
50.0 ×
Loop bandwidth well below the comparison frequency

The PLL frequency synthesizer calculator gives the output frequency, the comparison frequency, the step size, the phase noise multiplication and the approximate lock time of a phase-locked loop with dividers.

How the calculation works

  • Enter the reference frequency and the dividers R, N and P.
  • Enter the loop bandwidth.
  • The calculator gives the output, the VCO and comparison frequencies, the step, the phase noise multiplication, the lock time and the bandwidth check.

Example

A 25 MHz reference divided by R = 5 gives 5.0000 MHz at the phase detector. With N = 400, the VCO runs at 2,000.0000 MHz. An output divider P = 2 gives 1,000.0000 MHz, adjustable in steps of 2.5000 MHz. The phase noise at the output is raised by 20 log10(400 / 2) = 46.0 dB. A loop bandwidth of 100 kHz locks in about 6.4 µs, and is 50.0 times below the comparison frequency.

Why it matters

The calculator helps radio engineers, electronics designers and students who choose the dividers of a synthesizer for a radio, a clock generator or a test instrument.

Good to know

The lock time is an order of magnitude, four time constants of a loop with that bandwidth, and real lock time also depends on the size of the frequency jump, the damping and the charge pump. Fractional-N synthesizers allow steps much smaller than the comparison frequency, with a higher comparison frequency and less noise, but they add fractional spurs. The VCO tuning range, the phase detector noise floor and the loop filter are not shown here, and they define the actual performance. The noise multiplication holds inside the loop bandwidth only: outside it, the VCO noise dominates.

The image frequency calculator covers receivers, the clock jitter calculator links jitter to resolution, the decibel addition calculator adds levels and the RC filter calculator designs simple filters.

Frequently asked questions

How does a PLL synthesizer set the frequency?

The reference is divided by R, and the VCO output by N. The loop forces both to the same frequency, so the VCO runs at N × fref / R. Changing N moves the output in steps equal to the comparison frequency, divided by P if an output divider follows.

Why does the phase noise increase?

Within the loop bandwidth, the noise of the reference and of the phase detector is multiplied by N, which is 20 log10 N in decibels. A smaller N, reached with a higher comparison frequency, gives lower noise, but a fine step size requires a small comparison frequency.

How wide can the loop bandwidth be?

A common guideline keeps it below one tenth of the comparison frequency, to filter the reference sidebands and keep the loop stable. A wider loop locks faster but lets more reference noise through, so the design is a compromise.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.