Skip to content
Omnikalc

How much is your propeller slipping?

Enter the engine speed, the gear ratio, the propeller pitch and your GPS speed: get the theoretical speed, the slip percentage and the pitch for a 15% slip.

Updated on
Your inputs
rpm

Value out of range

Value out of range

Value out of range

Value out of range

Results

Propeller slip

19.8%

Normal slip for a planing boat: 10% to 25%
Propeller speed
2,888 rpm
Theoretical speed with no slip
49.9 kt
Pitch that would give a 15% slip
19.8 in

A boat propeller is like a screw: in one turn it would advance by its pitch, if it were turning in a solid. In water it slips, and the boat moves less. The slip tells you how well the propeller matches the boat and the engine. This calculator compares the theoretical speed from the engine speed, the gear ratio and the pitch with the actual speed measured by GPS, and gives the slip and the pitch that would give a typical 15 percent slip.

How the calculation works

  • Propeller speed = engine rpm ÷ gear ratio
  • Theoretical speed (knots) = propeller rpm × pitch in inches ÷ 1,215.2
  • Slip = (1 − actual speed ÷ theoretical speed) × 100
  • Pitch for a given slip = actual speed ÷ (1 − slip) × 1,215.2 ÷ propeller rpm

Example

An outboard turns at 5,400 rpm through a 1.87:1 gearbox, with a 21 in pitch propeller. The propeller turns at 2,888 rpm, and the theoretical speed is 49.9 knots. The boat does 40 knots on the GPS: the slip is 19.8%, normal for a planing boat. For a 15 percent slip at the same speed, a pitch of about 19.8 in would be needed.

Where it is used

Propeller choice is a trade-off between acceleration and top speed. A boat that cannot reach the top of its rpm range needs a lower pitch, and one that over-revs needs a higher pitch. Each inch of pitch changes the engine speed by about 150 to 200 rpm. Slip is also used to check for a damaged or fouled propeller, a dirty hull or an overloaded boat.

Good to know

The constant 1,215.2 converts inches times revolutions per minute into knots. For speeds in miles per hour or kilometres per hour, the calculator converts your input to knots first. Slip depends on the load, the trim and the hull, so compare it only under similar conditions. Always keep the engine within the rpm range specified by its maker at full throttle.

For the displacement speed limit of a hull, use the hull speed calculator. The motor speed calculator converts speeds and gear ratios, and the metacentric height calculator checks the stability of a boat.

Frequently asked questions

What is propeller slip?

The difference between the distance the propeller would advance in a solid, like a screw in wood, and the distance the boat actually travels. It is expressed as a percentage of the theoretical advance.

What is a normal slip?

Roughly 10 to 25 percent for a well-matched propeller on a planing boat. Heavier or displacement boats and sailboats under power run 30 to 50 percent or more.

How do I choose a pitch?

Pick a pitch that lets the engine reach the middle to upper part of its rated rpm range at full throttle. Too high a pitch overloads the engine, and too low a pitch lets it over-rev and wastes speed.

Is the real speed measured through the water or over the ground?

Use the speed through the water for a precise slip, but GPS speed over the ground is accurate enough when there is little current.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.