Skip to content
Omnikalc

Box joint layout calculator

Enter the board width, the finger width you want and the board thickness to get an odd number of fingers, the exact finger width to cut, the fingers on each board and the glue area.

Updated on
Your inputs
in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Results

Number of fingers and sockets across the width

13

Exact finger width to cut

0.462 in

Fingers on the board with fingers at the edges
7
Fingers on the mating board
6
Finger length to cut (thickness plus proud)
0.766 in
Glue area of the side faces
6.89 in²
Difference from the finger width wanted
-7.7 %

The box joint layout calculator gives the number of fingers, the exact finger width to cut, the fingers on each of the two boards and the side glue area for a board of a given width, rounded to an odd count so that the edges mate correctly.

How the calculation works

  • Enter the board width, the finger width you would like and the board thickness.
  • Enter how much the fingers are left proud for the final sanding.
  • Read the number of fingers and the exact width to set on the saw.

Example

A board of 6 in with fingers of 0.5 in wanted gets 13 fingers of 0.462 in, which is -7.7 % away from the wish. One board has 7 fingers and the other 6. The fingers are cut 0.766 in long, and the side faces give 6.89 in² of glue area.

Why it matters

The calculator helps woodworkers who build boxes, drawers, chests and toolboxes with a table saw or a router jig, and who want a symmetrical joint without a part finger at the edge. It gives the setting that makes the fingers fit the board exactly.

Good to know

Always cut the fingers to the exact width the calculator gives and not to the nearest drill or blade size, because even a small difference accumulates across several fingers. Test the setup on a scrap of the same thickness and adjust the jig by thin shims. Cut both boards with the same setup, and keep the same face against the fence. A sharp flat-top blade gives clean sockets, and the glue is applied on the side faces rather than on the end grain.

The dovetail joint calculator lays out tails and pins, the pocket hole calculator handles another joint, the router bit speed calculator sets the speed and the plywood sheets calculator estimates the sheet material.

Frequently asked questions

Why must the number of fingers be odd?

In a box joint, fingers and sockets alternate across the width. For both boards to start and end with the same type at the edges, with a finger at the edge of one board and a socket at the edge of the other, the total count must be odd. An odd count also lets the corner look symmetrical.

How is the finger width found?

Divide the board width by the number of fingers. The calculator rounds the ideal ratio of width to finger width to the nearest odd integer, so the exact width is slightly different from the wish. Set the blade or dado stack to the exact width, and cut the joint with a jig that shifts by that same step.

How long should the fingers be?

Fingers are cut as long as the mating board is thick, plus a small amount, about 1/64 inch or 0.4 millimeter, left proud. After gluing, the proud ends are sanded or planed flush. Too much proud wastes effort, while too little leaves a recess you cannot fix.

How strong is a box joint?

The side faces of the fingers give long-grain to long-grain gluing, which is strong, and the many fingers spread the load. Narrower fingers give more glue area but less strength against splitting. A finger width of about the board thickness is a common choice for boxes and drawers.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.