Skip to content
Omnikalc

Contour interpolation and spot elevation calculator

Enter two spot elevations, the distance between them and the position of a point to get its elevation, the slope and the distance at which a contour elevation crosses the line.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

Results

Elevation at the new point

101.94 ft

Slope between the points
8.065 %
Run for 1 ft of rise
12.4 ft
Distance from point 1 to the target elevation
24.8 ft

The contour interpolation calculator gives the elevation of a point between two spot elevations, the slope between them and the distance from the first point at which a contour elevation crosses the line.

How the calculation works

  • Enter the elevations of the two known points and the horizontal distance between them.
  • Enter the distance from point 1 to the new point and, if you want a contour, the target elevation.
  • The calculator gives the elevation of the new point, the slope, the run for 1 ft of rise and the distance to the target elevation.

Example

Two spot elevations are 100 ft and 105 ft, 62 ft apart. A point 24 ft from the first has an elevation of 100 + 5 × 24 / 62 = 101.935 ft. The slope is 5 / 62 = 8.065 %, which is 12.4 ft of run for each foot of rise. The 102 ft contour crosses the line at 2 × 62 / 5 = 24.8 ft from the first point.

Why it matters

The calculator helps surveyors, civil engineers, site planners, landscapers and students to read a grading plan, to find the elevation of a stake between contours and to locate the line of a contour on the ground.

Good to know

Use the horizontal distance between the points, not the distance along the ground, and put the elevations in the same datum and unit. Interpolate along a line where the ground slopes evenly, and add a point wherever the ground changes its slope, such as at a ditch or a ridge. To place a contour, enter its elevation as the target elevation, and repeat the calculation for each pair of spot elevations that the contour crosses. For design grades, round the result to the precision of the plan and check the slope against the limits of the project.

The grade stake calculator gives the cut or fill at a stake, the slope stake calculator finds the catch point of a slope, the average end area calculator gives the volume between sections and the stadia calculator gives the distance and the elevation from an instrument.

Frequently asked questions

What is contour interpolation?

Contour interpolation finds the elevation of a point between two points of known elevation, or the place on the line where a given elevation falls, by assuming that the ground slopes evenly between them. It is the method used to draw contour lines from spot elevations and to find the elevation at a point that is not at a contour.

What are the formulas?

The elevation of the new point is E1 + (E2 − E1) × d1 / D, where D is the horizontal distance between the points and d1 is the distance from point 1. The slope is (E2 − E1) / D, and the position of a contour of elevation Et is d = (Et − E1) × D / (E2 − E1) from point 1.

How accurate is it?

The result is exact only if the ground is a straight slope between the points. A hump or a hollow between them is not seen. The closer the spot elevations, the better the result. For design grades, measure the points on the line itself, and use a survey instrument for the final grades.

What does the calculator leave out?

The calculator leaves out the curvature of the ground, the breaks in slope, the difference between the slope distance and the horizontal distance, and the vertical datum. Make sure that all the elevations are in the same datum, and that the distance is measured horizontally.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.