Skip to content
Omnikalc

How much does a geothermal heat pump cost?

Enter the system size and the price per ton, the ground loop, the ductwork, the installation, the federal tax credit and the yearly energy savings: get the total, the credit, the net cost and the payback time.

Updated on
Your inputs
tons

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

%

Value out of range

$

Value out of range

Results

Net cost

$18,900

Total cost
$27,000
Tax credit
$8,100
Payback time
12.6 years
The ground loop is the biggest and most variable cost: vertical boreholes cost more than horizontal trenches but need little yard space; the loop lasts 50 years or more and the heat pump 20 to 25 years, so payback is best when replacing propane, oil or electric resistance heat

This calculator gives estimates for education and planning. It is not investment, tax or legal advice; for decisions about your own situation, talk to a qualified financial professional. A geothermal heat pump, also called a ground-source heat pump, moves heat between your house and the ground, which stays at roughly 50 to 60°F all year a few feet down. Fluid circulates through buried pipes, the ground loop, and the heat pump concentrates that heat for heating in winter and sends heat back into the ground for cooling in summer. It is one of the most efficient ways to heat and cool a home, but the loop makes it expensive to install. This calculator adds the heat pump, the loop, the ductwork and the installation, subtracts the federal tax credit, and estimates the payback.

How the calculation works

  • Total cost = system size in tons × price per ton + ground loop + ductwork + installation
  • Tax credit = total cost × credit rate
  • Net cost = total cost − tax credit
  • Payback time = net cost ÷ energy savings per year

A 4-ton system at $3,000 per ton with a $10,000 ground loop, $2,000 of ductwork and $3,000 of installation costs $27,000. A 30% tax credit of $8,100 brings the net cost to $18,900. Saving $1,500 a year, it pays for itself in about 12.6 years.

Typical prices

Item Typical price
Heat pump unit, per ton $2,000 to $4,000
Horizontal loop in trenches $5,000 to $15,000
Vertical boreholes $10,000 to $30,000
New or modified ductwork $1,000 to $10,000
Installation and startup $2,000 to $5,000

Choosing a loop

Horizontal loops are laid in trenches 4 to 6 feet deep and are cheapest where there is plenty of land. Vertical loops are drilled 150 to 400 feet deep and suit small lots. Pond loops are the cheapest of all if you have a suitable body of water, and open-loop systems use well water directly where local rules allow. The loop typically lasts 50 years or more, while the heat pump itself lasts 20 to 25 years.

Incentives and savings

Check the current federal tax credit and any state or utility rebates when you plan the project, because these programs change; some utilities also offer lower electricity rates for heat pumps. Savings are greatest when you replace propane, heating oil or electric baseboards, and smaller when you replace an efficient gas furnace. A geothermal system can also preheat your domestic hot water with a desuperheater. A Manual J load calculation should set the system size rather than a rule of thumb.

Frequently asked questions

How much does a geothermal heat pump cost?

About $27,000 for a 4-ton system with a ground loop, ductwork and installation.

What does geothermal cost after the tax credit?

About $18,900 after a 30% credit in the default case.

What is the payback of a geothermal heat pump?

About 12.6 years when it saves $1,500 a year.

How long does a geothermal ground loop last?

50 years or more; the heat pump lasts 20 to 25 years.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.