A recipe predicts a gravity, and your equipment decides whether you reach it. The brewhouse efficiency calculator takes the grain weight, its extract potential, the volume in the fermenter, the efficiency you expected and the measured original gravity and gives the predicted gravity, the efficiency you achieved, the gravity points missed and the grain needed at your real efficiency.
How the calculation works
- Extract available = grain weight × extract potential. A pound of pale malt can give about 36 gravity points in a gallon of wort.
- Predicted gravity points = grain weight × potential × expected efficiency ÷ volume. The predicted gravity is 1 + points ÷ 1 000.
- Efficiency achieved = measured gravity points × volume ÷ (grain weight × potential). It is the share of the possible extract that reached the fermenter.
- Points missed = predicted points − measured points.
- Grain needed at your real efficiency = the weight that would give the predicted gravity at the efficiency you actually reached.
Example
A brewer mashes 11 lb of grain rated 36 PPG and collects 5.5 gal, expecting 72 percent. The predicted gravity is 1 + (11 × 36 × 0.72 ÷ 5.5) ÷ 1 000 = 1.052. The measured gravity is 1.048, so the extract that arrived is 48 × 5.5 ÷ (11 × 36) = 66.7 percent, which is 3.8 points short. To reach 1.052 at this efficiency, the brewer needs 11.9 lb of grain.
Why it matters
Knowing your own efficiency is the key to hitting the gravity of a recipe. After two or three batches you can enter your usual figure, scale recipes with confidence, and notice at once when a change of crush, mash or sparge helps or hurts.
Good to know
The calculation treats all the grain as one blend with a single potential. Recipes with sugar or extract should be counted separately, and the grain weight should include only mashed grain. Measure the gravity at a known temperature, correct a reading taken warm, and use the volume that you really put into the fermenter.
Related tools
The homebrew ABV calculator turns two gravity readings into a strength and the strike water temperature calculator sets the temperature of the mash water.