Skip to content
Omnikalc

Patellar tracking (Q-angle and TT-TG) calculator

Enter the distances from the iliac spine to the patella, from the patella to the tibial tubercle and from the iliac spine to the tibial tubercle for the Q-angle, and the distances of the tubercle and the groove from the posterior condylar line for the TT-TG.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
cm

Value out of range

cm

Value out of range

cm

Value out of range

mm

Value out of range

mm

Value out of range

Results

TT-TG distance (tubercle minus groove)

16.0 mm

15 to 20 mm: a borderline value, to be read with the other findings
Q-angle (quadriceps angle)
15.0 °
Within the usual range (about 10 to 20 degrees, higher in women)

The patellar tracking calculator gives the Q-angle from three surface measurements and the tibial tubercle to trochlear groove (TT-TG) distance from two imaging distances, with the risk of patellar instability.

How the calculation works

  • Enter the three distances for the Q-angle.
  • Enter the tubercle and groove distances from the posterior condylar line.
  • Read the Q-angle and the TT-TG.

Example

With distances of 36 cm, 7 cm and 42.8 cm the angle at the patella is 165 degrees, and the Q-angle is 180 − 165 = 15.0 degrees, within the usual range. A tubercle at 38 mm and a groove at 22 mm from the condylar line give a TT-TG of 38 − 22 = 16.0 mm, a borderline value.

Why it matters

The calculator helps orthopedic surgeons, sports physicians, radiologists and physiotherapists who assess a patient with patellar instability or anterior knee pain, and students who learn the measurements.

Good to know

The three-distance method for the Q-angle uses the law of cosines, with the angle at the patella between the lines to the iliac spine and to the tibial tubercle subtracted from 180 degrees, and it is a way to measure the angle with a tape measure. The clinical Q-angle is normally between 10 and 20 degrees, 13 degrees on average in men and 18 in women, but its link to knee pain is weak. The TT-TG distance was proposed by Goutallier and Bernageau in 1978, and Dejour showed that it is above 20 mm in most patients with recurrent dislocation and under 10 to 15 mm in controls. Values of 15 to 20 mm are borderline and the decision on surgery depends on other factors such as patella alta, trochlear dysplasia, the tilt of the patella and the number of dislocations. A tibial tubercle osteotomy medializes the tubercle to reduce the TT-TG. The measurement varies with the rotation of the knee and the slice chosen, so the same protocol must be used, and the result should be read with the radiologist. This calculator is for education.

The patellar height calculator reads the X-ray of the same knee, the Lysholm calculator scores knee function, the range of motion calculator follows bending and the arch index calculator measures the foot.

Frequently asked questions

What is the Q-angle?

It is the angle between the line of pull of the quadriceps, from the hip to the center of the patella, and the line of the patellar tendon, from the patella to the tibial tubercle. A larger angle pushes the patella outward.

What is the TT-TG distance?

It is the distance, on a CT or MRI scan, between the tibial tubercle and the deepest point of the trochlear groove of the femur, both projected on the posterior condylar line. It reflects how far lateral the tendon inserts.

Which is more reliable?

The TT-TG on imaging is more reproducible than the clinical Q-angle, which varies with the position of the foot, the contraction of the muscle and the observer. The clinical angle is a screening measure.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.