Skip to content
Omnikalc

Aircraft climb gradient calculator

Enter the ground speed, the rate of climb and the gradient required by a departure procedure to get the climb gradient in feet per nautical mile, in percent and in degrees, with the rate of climb you need.

Updated on
Your inputs
kt

Value out of range

ft/min

Value out of range

ft/NM

Value out of range

ft

Value out of range

Results

Climb gradient

467 ft/NM

Rate of climb needed for the required gradient

600 ft/min

Climb gradient in percent
7.68 %
Climb angle
4.39 °
Margin over the required rate
100 ft/min
Time to gain the altitude
4.3 min
Distance covered during the climb
6.4 NM

The aircraft climb gradient calculator converts a rate of climb and a ground speed into a climb gradient in feet per nautical mile, in percent and in degrees, and finds the rate of climb needed to meet the gradient required by a departure procedure.

How the calculation works

  • Enter the ground speed in knots and the rate of climb in feet per minute.
  • Enter the required gradient of the procedure and the altitude to gain.
  • Read the gradient, the rate of climb needed, the margin, the time and the distance.

Example

Climbing at 700 ft/min with a ground speed of 90 kt gives a gradient of 467 ft/NM, which is 7.68 % or an angle of 4.39 °. A procedure that requires 400 ft/NM needs 600 ft/min, so the margin is 100 ft/min. Gaining 3000 ft takes 4.3 min and 6.4 NM.

Why it matters

The calculator helps pilots and students plan an instrument departure, check that an aircraft can meet an obstacle clearance gradient, or understand how the wind changes the climb path over the ground. It turns a figure in feet per nautical mile into a rate of climb that the instruments show.

Good to know

Use the true ground speed, which includes the wind, because the gradient is measured over the ground. For a safe climb on a departure procedure, take the speed for the whole climb and not only the first minute, and remember that the rate of climb falls with altitude and temperature. The performance chart of the aircraft gives the rate of climb at the weight and the density altitude of the day. A negative margin means that the aircraft cannot meet the procedure and another departure is needed.

The top of descent calculator plans the way down, the density altitude calculator shows the effect of the weather on performance, the aircraft turn performance calculator handles banked turns and the wind triangle calculator gives the ground speed.

Frequently asked questions

What is a climb gradient?

A climb gradient is the altitude gained per unit of horizontal distance. Aviation charts give it in feet per nautical mile, and a percent gradient is the same slope as a ratio. For a given rate of climb, the gradient depends on the ground speed: climbing at 700 feet per minute at 90 knots gives about 467 feet per nautical mile.

How is the gradient calculated?

The gradient in feet per nautical mile is the rate of climb in feet per minute multiplied by 60 and divided by the ground speed in knots. To get a percent, divide by 6,076 feet, the length of a nautical mile, and multiply by 100. The angle is the arctangent of that ratio.

Why do departure procedures give a gradient?

Instrument departure procedures ask for a minimum climb gradient, often 200 feet per nautical mile by default and more where terrain or obstacles are close. A pilot converts the gradient into a rate of climb for the expected ground speed, and checks that the aircraft can reach it in the conditions of the day.

What changes the gradient in flight?

A headwind lowers the ground speed and so steepens the gradient for the same rate of climb, while a tailwind flattens it. High temperature and altitude lower the rate of climb, and so the gradient. The calculation uses the ground speed, not the airspeed, because obstacles are fixed to the ground.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.