Skip to content
Omnikalc

Aircraft turn calculator: how tight is your turn?

Enter the true airspeed and the bank angle to get the rate of turn, the turn radius, the time for a full circle, the load factor, the stall speed increase and the standard-rate bank.

Updated on
Your inputs

Value out of range

°

Value out of range

Results

Rate of turn

5.25 °/s

Turn radius
673 m
Time for a full circle
1:09
Load factor
1.15 g
Gentle load on the aircraft
Stall speed increase
7.5 %
Bank angle for a standard-rate turn (3° per second)
18.2 °

A bank angle sets how fast and how tightly an aircraft turns. The aircraft turn calculator takes the true airspeed and the bank angle and gives the rate of turn, the turn radius, the time for a full circle, the load factor, the increase in stall speed and the bank angle of a standard-rate turn.

How the calculation works

  • Rate of turn = g × tan(bank angle) ÷ true airspeed, in radians per second, converted to degrees. A faster aircraft turns more slowly at the same bank.
  • Turn radius = airspeed² ÷ (g × tan(bank angle)). The radius grows with the square of the speed.
  • Time for a full circle = 360° ÷ rate of turn.
  • Load factor = 1 ÷ cos(bank angle). The wings must carry this many times the weight in a steady, level turn: 1.15 g at 30°, 1.41 g at 45° and 2 g at 60°.
  • Stall speed increase = (√load factor − 1) × 100, since the stall speed rises with the square root of the load factor.
  • Standard-rate bank = arctan(airspeed × 3° per second in radians ÷ g), the bank angle that gives a turn of 3° per second.

Example

An aircraft flies at 120 kt (61.7 m/s) in a 30° bank. The rate of turn is 9.807 × tan 30° ÷ 61.7 = 0.0917 rad/s, which is 5.25°/s. The radius is 61.7² ÷ (9.807 × 0.577) = 673 m, a full circle takes 1:09, the load factor is 1.15 g, and the stall speed rises by 7.5 percent. A standard-rate turn at this speed needs a bank of 18.2°.

Why it matters

Pilots use these numbers to plan holding patterns, to fit a turn inside a valley or an airport circuit, and to understand why steep turns are harder and riskier than shallow ones. The calculator also shows why a fast aircraft needs a wide circle for the same bank.

Good to know

The formulas describe a steady, coordinated, level turn with no wind effect, and they use the true airspeed. This is a planning and learning aid. It does not replace the flight manual of an aircraft, its operating limits, or the training of a pilot. Real aircraft also lose some altitude or speed in a turn if the pilot does not adjust the power and the pitch.

The true airspeed calculator converts indicated speed to true speed and the density altitude calculator shows how heat and height affect an aircraft’s performance.

Frequently asked questions

What is a standard-rate turn?

A standard-rate turn, or rate one, is a turn of 3 degrees per second, which takes two minutes to make a full circle. Instruments such as the turn coordinator mark it. The bank angle needed rises with the speed, and at about 120 kt it is a bank of 18 degrees.

Why does a steeper bank raise the stall speed?

In a level turn the lift must be greater than the weight, because part of it turns the aircraft. At 60° of bank the wings carry twice the weight, so the stall speed is about 41 percent higher. This is why a steep turn at low speed near the ground is dangerous.

Does the turn depend on the weight of the aircraft?

No. The rate and the radius of a coordinated level turn depend only on the airspeed and the bank angle. The weight changes the load on the wings and the power needed, and the stall speed, but not the geometry of the turn.

Is the radius measured over the ground?

No, it is the radius relative to the air. A wind pushes the whole path, so over the ground the turn stretches downwind and the radius appears to change. The calculation also assumes constant altitude and true airspeed, and a coordinated turn with no slip or skid.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.