Rolling bearings do not wear out gradually: they fail from fatigue under the repeated stress of the rolling elements. The basic rating life, L10, estimates how long a bearing lasts under a given load and speed. This calculator takes the dynamic load rating from the catalogue, the load on the bearing and the speed, and returns the life in million revolutions, in operating hours and in years of service.
How the calculation works
- Life L10 = (C ÷ P)^p, in millions of revolutions, with p = 3 for balls and 10/3 for rollers
- Adjusted life = reliability factor × L10
- Operating hours = L10 × 1,000,000 ÷ (60 × rpm)
- Years = hours ÷ (hours per day × 365)
Example
A bearing with a dynamic rating of 30 kN carries a load of 3 kN at 1,500 rpm. The load ratio is 10, so the life is 10³ = 1,000 million revolutions. At 1,500 rpm this is 11,111 hours. Running 8 hours a day, the bearing lasts about 3.8 years. If the load doubled to 6 kN, the life would fall to about 1,389 hours.
Where it is used
Choosing a bearing for a motor, a pump, a gearbox, a wheel or a fan starts with this calculation. Typical design targets are 8,000 to 12,000 hours for intermittent machines, 20,000 to 30,000 hours for continuous industrial equipment and more for critical systems. The reliability factor lets you design for 95 or 99 percent survival instead of 90 percent.
Good to know
The equivalent load combines radial and axial loads using factors from the bearing catalogue. Real life depends on lubrication, contamination, temperature, alignment and fitting, which manufacturers account for in modified life ratings. Very light loads can also cause skidding, and a load that is too high can cause early failure. Always use the manufacturer’s data for a safety-critical application.
Related tools
For the torque and speed of the shaft, use the torque and motor speed calculators. The shaft torsion calculator checks the stress in the shaft, and the bolt torque calculator covers the fasteners.