Skip to content
Omnikalc

Dead reckoning position calculator

Enter the starting latitude and longitude, the true course, the ground speed and the time to get the distance run, the departure, the change of latitude and longitude and the estimated position.

Updated on
Your inputs
°

Value out of range

°

Value out of range

°

Value out of range

kt

Value out of range

h

Value out of range

Results

Estimated latitude

45.824 °

Estimated longitude

-63.192 °

Distance run
330.0 NM
Departure (east-west distance)
299.1 NM
Change of latitude
139.5 ′
Change of longitude
420.5 ′

The dead reckoning position calculator gives the estimated position after a leg from the starting latitude and longitude, the true course, the ground speed and the time, with the distance run, the departure and the changes of latitude and longitude.

How the calculation works

  • Enter the starting latitude and longitude in decimal degrees, with north and east positive.
  • Enter the true course, the ground speed and the time underway.
  • Read the estimated position and the distances.

Example

From 43.5 ° and -70.2 °, a course of 65 ° at 110 kt for 3 h covers 330.0 NM, of which 299.1 NM is the east-west departure. The latitude changes by 139.5 ′ and the longitude by 420.5 ′, which puts the estimated position at 45.824 ° and -63.192 °.

Why it matters

The calculator helps sailors, pilots, hikers and students plot an estimated position, check a plotted fix, or understand why a degree of longitude is shorter than a degree of latitude away from the equator. It is a quick method that needs only the course, the speed and the time.

Good to know

Use the true ground speed and the true course over the ground, and not the heading or the airspeed, otherwise the wind and the current are ignored. The calculation assumes a straight leg at constant speed; for a route with several legs, run each leg from the position of the previous one. The mean latitude method fits legs of a few hundred miles. Always confirm the position with a visual or electronic fix when you can.

The wind triangle calculator gives the ground speed and the heading, the flight fuel planning calculator estimates the fuel, the DME arc calculator handles arcs and the top of descent calculator plans the descent.

Frequently asked questions

What is dead reckoning?

Dead reckoning is navigation from a known starting point using the course, the speed and the time. The distance is the speed multiplied by the time, and the new position follows from the direction. Sailors and pilots used it before satellite navigation and still keep it as a backup, because it needs no outside signal.

How are latitude and longitude computed?

One minute of latitude is one nautical mile, so the change of latitude in minutes is the distance times the cosine of the course. The east-west distance, the departure, is the distance times the sine of the course. One minute of longitude is only cos(latitude) nautical miles, so the change of longitude is the departure divided by the cosine of the mean latitude.

How accurate is it?

The error grows with time, because small errors in course, speed, current or wind add up. After a few hours it may be several miles. Mark the estimated position often, correct it when a fix is available, and use the true ground track when the wind is known.

Is this valid at high latitudes?

The method uses the mean latitude and is a plane approximation that is good for legs of a few hundred miles at moderate latitudes. Close to the poles, or for very long legs, great-circle formulas are needed. The calculator limits latitude to 80 degrees.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.