Skip to content
Omnikalc

DME arc calculator

Enter the ground speed, the arc radius in nautical miles and the angle of arc to fly to get the heading change per minute, the bank angle, the lead distance to start the turn and the time on the arc.

Updated on
Your inputs
kt

Value out of range

NM

Value out of range

°

Value out of range

Results

Heading change needed

9.5 °/min

Bank angle to hold the arc

1.0 °

Lead distance to turn onto the arc (standard rate)

1.91 NM

Turn rate
0.16 °/s
Time to fly the angle of arc
6.3 min
Length of the arc flown
12.6 NM

The DME arc calculator gives the heading change per minute, the bank angle, the lead distance and the time on the arc for a flight at constant distance from a DME station, from the ground speed, the arc radius and the angle of arc to fly.

How the calculation works

  • Enter the ground speed in knots and the arc radius in nautical miles.
  • Enter the angle of arc to fly, in degrees.
  • Read the heading change, the bank, the lead distance and the time.

Example

On an arc of 12 NM at 120 kt, the heading must change by 9.5 °/min, a turn rate of 0.16 °/s. The bank needed is only 1.0 °. The lead to roll onto the arc at standard rate is 1.91 NM. Flying 60 ° of arc covers 12.6 NM and takes 6.3 min.

Why it matters

The calculator helps instrument pilots and students prepare arc approaches, check the workload of a given radius and speed, and understand why small arcs at high speed are demanding. It gives the figures used for the heading changes that keep the aircraft on the arc.

Good to know

Use the ground speed of the arc, which changes with the wind as the aircraft goes around the station, so the heading change per minute is an average. In practice a pilot flies the arc by checking the DME and the bearing and by correcting the heading in steps of 5 to 10 degrees. Start slowing down before the arc to reduce the lead. The calculation is a guide for planning and does not replace the procedure chart or the instructions of air traffic control.

The aircraft turn performance calculator treats banked turns, the wind triangle calculator gives the ground speed, the climb gradient calculator checks departure procedures and the top of descent calculator plans the descent.

Frequently asked questions

What is a DME arc?

A DME arc is a path flown at a constant distance from a DME station. The aircraft keeps the distance on the display constant by turning slowly toward the station, so the track is part of a circle around the station. Instrument approaches use arcs to bring an aircraft from an airway to the final approach course.

How fast must the heading change?

On a circle of radius r flown at the ground speed V, the heading changes by V / r radians per hour, or 57.3 × V / (60 × r) degrees per minute when V is in knots and r in nautical miles. At 120 knots on a 12-mile arc, that is about 9.5 degrees per minute, so a turn of 1 degree every 6 seconds.

What bank angle does an arc need?

The bank angle follows from the centripetal acceleration, tan(bank) = V² / (g × r). For a 12-mile arc at 120 knots it is about 1 degree, so the aircraft needs almost no bank and the pilot steers by small heading corrections. The bank grows with the square of the speed and falls with the radius.

How does the lead distance work?

To roll onto the arc from a straight track, the pilot starts the turn before reaching the arc distance. A common rule is a lead of about the radius of a standard-rate turn, which is the ground speed divided by 63. At 120 knots that is about 1.9 miles. Strong winds change the lead needed and the heading to hold.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.