Before automatic flash metering, photographers set their exposure with a single number: the guide number. It is still the quickest way to know whether a flash can reach your subject at a given aperture, and to set a manual flash in a studio or at a party. This calculator adjusts the guide number for ISO and flash power, then shows the farthest reach and the aperture needed at your distance.
How the calculation works
The guide number printed on a flash is given for ISO 100 and full power. It is then scaled:
- Effective guide number = GN × √(ISO ÷ 100) × √(power fraction)
- Farthest distance = effective guide number ÷ aperture
- Aperture needed = effective guide number ÷ distance
The unit of distance must match the unit of the guide number: a GN of 36 in meters means 36 meters × f-number, while 118 feet means 118 feet × f-number. The calculator converts between the two so you can use either.
Example
A flash with a guide number of 120 feet (about 36.6 m) at ISO 100, used at ISO 400 and 1/8 power, has an effective guide number of 120 × 2 × 0.354 ≈ 85 feet. At f/5.6 it reaches 85 ÷ 5.6 ≈ 15 feet. For a subject at 10 feet, the aperture to use is 85 ÷ 10 = f/8.5.
Why it matters
Knowing the reach avoids underexposed backgrounds and blown-out foregrounds. It also helps you pick a flash: a small on-camera flash with a guide number of about 12 meters at ISO 100 is enough for a subject a couple of meters away, but not for a large room or an outdoor portrait in sunlight, where the flash is used only to fill shadows.
Good to know
The guide number is only a guide: it assumes an average, neutrally colored subject and a normal room. Zoom heads, diffusers and bounce cards change the real value, and some makers rate the number at the longest zoom. High-speed sync reduces output, because the flash fires in a series of short pulses. Take a test shot and adjust with the histogram. This tool is for education.
Related tools
The exposure value calculator links aperture, shutter and ISO, the depth of field calculator shows the effect of the aperture, and the ND filter calculator gives the shutter speed with a neutral density filter.