Skip to content
Omnikalc

Router guide bushing offset calculator

Enter the bushing outside diameter, the bit diameter and the inlay size you want to get the offset, the size of the template opening for the pocket and the size of the male template for the inlay plug.

Updated on
Your inputs
in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Results

Bushing offset

0.1875 in

Template opening for the pocket

2.3750 in

Male template size for the plug

1.6250 in

Difference between the two templates
0.7500 in
Smallest inside corner radius of the pocket
0.1250 in
Smallest inside corner radius of the template opening
0.3125 in

The router guide bushing offset calculator gives the offset of a guide bushing and the template opening and male template size needed to cut an inlay pocket and its matching plug at a chosen finished size.

How the calculation works

  • Enter the bushing outside diameter and the bit diameter.
  • Enter the finished inlay size and a glue gap on each side, if any.
  • Read the offset, the template opening, the male template and the corner radii.

Example

A bushing of 0.625 in with a bit of 0.25 in has an offset of 0.1875 in. An inlay of 2 in needs a template opening of 2.3750 in to cut the pocket and a male template of 1.6250 in to cut the plug. The two templates differ by 0.7500 in. The pocket has inside corners of at least 0.1250 in radius, and the opening 0.3125 in.

Why it matters

The calculator helps woodworkers who inlay strings, letters, medallions and decorative shapes with a router and a template, and who want the pocket and the plug to fit without trial and error. It gives the exact size of each template for the bushing and bit on hand.

Good to know

Measure the real outside diameter of the bushing and the real diameter of the bit with calipers, because the nominal values are often off by a few hundredths. Check that the bushing is centered on the collet and that the bit does not touch the bushing wall. Cut a test pocket and plug in scrap and adjust the glue gap. Use shallow passes, a sharp upcut bit for the pocket, and a light feed to avoid bit deflection which changes the size.

The router bit speed calculator sets the speed for the bit, the box joint calculator lays out fingers, the mortise and tenon calculator sizes another joint and the dovetail joint calculator treats a classic joint.

Frequently asked questions

What is the bushing offset?

A guide bushing is a ring around the bit that rides against the edge of a template. Because the ring is wider than the bit, the cut is set back from the template by half the difference between the two diameters: offset = (bushing diameter − bit diameter) / 2. This is the distance between the template edge and the cut.

How is the pocket sized?

When the bushing runs inside an opening in the template, the cut is smaller than the opening by the offset on each side. For a pocket of a given size, the opening must be larger by twice the offset. The result is a pocket exactly as big as the inlay when the glue gap is zero.

How is the plug sized?

When the bushing runs around the outside of a male template, the cut is larger than the template by the offset on each side. To cut a plug of the size of the pocket, the male template must be smaller by twice the offset. Using the same template for both operations gives a plug that is too small or too large by four times the offset.

Why is the inside corner round?

The bit has a round shape, so a pocket cannot have a sharp inside corner and the radius is at least the bit radius. The template opening has a radius at least equal to the bushing radius. A square inlay is cut round and the corners of the plug are then rounded to fit or the pocket is squared with a chisel.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.