Skip to content
Omnikalc

Steam quality (dryness fraction) calculator

Enter a property of the wet mixture and its saturated liquid and vapor values to get the quality, the moisture and the masses of liquid and vapor.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

kg

Value out of range

kJ/kg

Value out of range

Results

Quality (dryness fraction)

0.615

Quality in percent
61.5 %
Moisture content
38.5 %
Mass of vapor
6.15 kg
Mass of liquid
3.85 kg
Heat to evaporate the liquid
7.76 MJ

The steam quality calculator gives the quality (dryness fraction) of a wet mixture of water and steam, the moisture content, the mass of vapor and of liquid, and the heat needed to evaporate the remaining liquid.

How the calculation works

  • Enter a property of the mixture, enthalpy, specific volume or entropy.
  • Enter the same property for the saturated liquid and the saturated vapor at the same pressure, from the steam tables.
  • Enter the total mass and the latent heat at this pressure.

Example

A mixture with a property of 2000, between 762.5 for the liquid and 2776.2 for the vapor, has a quality of 0.615, or 61.5 %, and a moisture content of 38.5 %. In 10 kg, there are 6.15 kg of vapor and 3.85 kg of liquid. Evaporating the liquid takes 7.76 MJ.

Why it matters

The calculator helps thermal engineering students, boiler and steam system operators and energy auditors who must find the quality of wet steam from the steam tables or from a measurement.

Good to know

Use the three values from the same column of the table, for the same pressure or temperature, and keep the units consistent, kJ/kg for the enthalpy and m³/kg for the volume. The formula is valid only if the mixture is saturated, so the property must be between the liquid and vapor values. If it exceeds the vapor value, the steam is superheated and the quality is not defined. For volume, the values vary by orders of magnitude, so enter them with care. Check the result with a second property if the table gives one.

The flash steam calculator gives the vapor produced when pressure drops, the steam trap sizing calculator removes the condensate that wets the steam, the steam pipe sizing calculator sizes the lines and the Rankine cycle calculator uses the quality at the turbine exit.

Frequently asked questions

What is the quality of steam?

The quality, or dryness fraction, x is the share of the mass of a saturated mixture of water and steam that is vapor. It is 0 for saturated liquid and 1 for dry saturated steam. It applies only between the two states, since superheated steam is above 1 in the sense that it is dry. The remaining share, 1 − x, is liquid water.

How is it calculated?

Because the properties of a mixture are the mass-weighted average of the two phases, x = (y − yf) / (yg − yf), where y is the specific enthalpy, volume or entropy of the mixture, and yf and yg are the values for saturated liquid and saturated vapor at the same pressure. The values are in the steam tables. For 2 000 kJ/kg at 10 bar, x = 0.616.

Why does the steam quality matter?

Wet steam carries less energy per kilogram, so a boiler or a steam supply with a low quality gives less heat. The drops of water erode turbine blades and pipe fittings and reduce the effect of heat exchangers. Steam used for process heating typically has a quality above 0.95, and turbines require more than 0.88 at the exit.

How is it measured in practice?

A throttling calorimeter measures the temperature and the pressure after expanding the steam into the superheated region, and the enthalpy of the mixture follows. Separating and sampling calorimeters are used too. Good plants use separators and steam traps to dry the steam.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.