Skip to content
Omnikalc

Bandsaw blade length calculator

Enter the wheel diameter, the center distance and the tension travel to get the blade length, the range of blade lengths the machine takes and the center distance a given blade needs.

Updated on
Your inputs
in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Results

Blade length at this center distance

93.5 in

Center distance needed for the blade available

24.76 in

Shortest blade the machine takes
90.5 in
Longest blade the machine takes
96.5 in
Adjustment from the set center distance
0.01 in
Blade available fits (1 = yes, 0 = no)
1

The bandsaw blade length calculator gives the blade length for a bandsaw from the wheel diameter and the center distance, the range of lengths the machine takes with its tension travel, and the center distance a blade of a given length needs.

How the calculation works

  • Enter the wheel diameter and the center distance between the axles.
  • Enter the tension travel of the upper wheel and the blade length available.
  • Read the blade length, the range and whether the blade fits.

Example

A bandsaw with wheels of 14 in and a center distance of 24.75 in takes a blade of 93.5 in. With 1.5 in of travel it accepts blades from 90.5 in to 96.5 in. A blade of 93.5 in needs a center distance of 24.76 in, which is 0.01 in away from the current setting, and the fit result is 1.

Why it matters

The calculator helps woodworkers and metalworkers who buy a bandsaw blade for a used or unfamiliar machine, who build a bandsaw, or who want to check that a blade of a given length can be mounted and tensioned. It avoids buying a blade that is too short or too long.

Good to know

When in doubt, use the length recommended in the manual of the machine, because the exact center distance depends on where the wheel stops are. Measure the diameter of the wheels without the tires, or with them, according to how your blade runs, and keep the upper wheel near the middle of its travel to leave a margin for tension and wear. Folded blades can be mounted by twisting them into three loops. The formula applies to saws with two wheels of the same size.

The resaw and bookmatch calculator uses a bandsaw for thick boards, the kerf bending calculator plans cuts, the pulley calculator relates wheel sizes to speeds and the router bit speed calculator sets bit speeds.

Frequently asked questions

How is the blade length computed?

For two wheels of the same diameter D with a center distance C, the blade runs over half of each wheel and along two straight spans, so L = 2C + π × D. A bandsaw with 14-inch wheels and a center distance of 24.75 inches takes a blade of about 93.5 inches, which is the most common size for a 14-inch saw.

What if the wheels have different diameters?

The calculator assumes two wheels of the same size, as on most woodworking bandsaws. For different diameters, the length is 2C + π × (D1 + D2) / 2 + (D1 − D2)² / (4C). The difference is small if the diameters are close, but a three-wheel saw needs a separate calculation.

Why does the machine take a range of lengths?

The upper wheel moves up and down for the tension and the tracking. Moving it by a distance T changes the blade length by 2 × T, so a saw with 1.5 inches of travel takes blades about 3 inches shorter or longer than the middle length. Near the ends of the travel, tracking and tension are poor.

How do I measure the real center distance?

Measure from the axle of the top wheel to the axle of the bottom wheel with the upper wheel at the middle of its travel. A simple method is to wrap a string along the wheels as a blade would run, then measure it. Or use the manufacturer’s blade size, which is given in the manual.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.