Skip to content
Omnikalc

Hydrometer temperature correction calculator: fix a gravity reading taken at the wrong temperature

Enter the hydrometer reading, the sample temperature and the calibration temperature to get the corrected specific gravity, the degrees Plato and the potential alcohol of a wort or must.

Updated on
Your inputs

Value out of range

°F

Value out of range

°F

Value out of range

Results

Corrected specific gravity

1.0524

Correction
2.4 points
Degrees Plato
12.97 °P
Potential alcohol if it ferments down to 1.010
5.57 %

A hydrometer is calibrated for one temperature, and a warm sample reads too low. The hydrometer temperature correction calculator converts a reading taken at any temperature to the corrected specific gravity at the calibration temperature, and gives the degrees Plato and the potential alcohol.

How the calculation works

  • Enter the reading of your hydrometer and the temperature of the sample when you read it.
  • Enter the calibration temperature printed on the hydrometer, usually 60 °F (15.6 °C) for brewing, or 68 °F (20 °C) in some countries.
  • The calculator corrects the reading with the density of water at the two temperatures: a warm liquid is lighter, so the hydrometer reads too low.
  • The result is the corrected gravity, the correction in points, the degrees Plato and the potential alcohol if the fermentation ends at 1.010.

Example

A brewer reads 1.050 on a hydrometer calibrated at 60 °F, but the wort is still at 80 °F. The corrected specific gravity is 1.0524, which is 2.4 points higher. The wort is 12.97 °P, and if it ferments down to 1.010, the beer will have 5.57 % alcohol.

Why it matters

The calculator helps brewers, winemakers, cider makers and mead makers to avoid waiting for the sample to cool or to correct a reading from a fermenter that is warm. It gives a reliable original gravity for the calculation of the alcohol and of the efficiency.

Good to know

The correction is for a sugar solution with a density close to that of water at the temperature of the sample. A sample that is too hot (above 100 °F or 38 °C) gives a result that is less accurate, and a very dense must needs a cooling. The hydrometer must float freely, without touching the walls, and you should read the bottom of the meniscus at the eye level. The calculator does not correct for alcohol, which lowers the gravity during the fermentation.

The brewhouse efficiency calculator uses the gravity of the wort, the priming sugar calculator gives the sugar for carbonation, the spirit dilution calculator brings a spirit to a target strength, and the wine sulfite calculator doses sulfites in a must or a wine.

Frequently asked questions

Why does temperature change the reading?

A hydrometer floats in a liquid according to its density, and the density of a liquid decreases when it is warm. A hydrometer that is calibrated at 60 °F reads the true gravity only at that temperature. In a wort at 80 °F, the hydrometer sinks more and shows a number that is too low, about 2 points for 20 °F (about 1 point for each 10 °F above the calibration, when you are close to it, and more above).

What temperature should I measure at?

The best is to cool the sample to the calibration temperature of the hydrometer, which is 60 °F (15.6 °C) for most brewing hydrometers and 68 °F (20 °C) for many wine ones. A small sample cools in a few minutes in a bath of cold water. The correction is made for samples that are not too far from the calibration: keep them between 50 and 100 °F (10 and 38 °C) if possible.

How good is this correction?

It uses the density of pure water at the two temperatures, with a polynomial fit. For a wort or a must, the density of the sugar solution changes in a slightly different way, but the difference is under 0.0005 for the usual temperatures. The reading error of the hydrometer, its calibration and the bubbles of CO2 on the stem are usually much bigger, up to 0.001 or 0.002.

What are degrees Plato and potential alcohol?

Degrees Plato (°P) is the mass percent of sugar in a wort, and it is close to °Brix: a wort of 12 °P has about 12 grams of extract in 100 grams. The potential alcohol is the alcohol by volume of a finished beer if the gravity goes from the corrected reading to 1.010, using the common formula ABV = (OG − FG) × 131.25. The real value depends on the yeast and on the sugars.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.