Skip to content
Omnikalc

AM modulation power calculator

Enter the carrier power, the modulation depth and the highest audio frequency to get the total power, the power in the sidebands, the efficiency, the peak envelope power and the bandwidth.

Updated on
Your inputs
W

Value out of range

%

Value out of range

kHz

Value out of range

Results

Total radiated power

132.00 W

Power in each sideband
16.00 W
Power in both sidebands
32.00 W
Efficiency (sideband power share)
24.2 %
Peak envelope power
324.00 W
Bandwidth
10.00 kHz
Twice the highest audio frequency
Modulation depth check
80 %
No overmodulation

The AM modulation power calculator gives the total power, the power in the sidebands, the efficiency, the peak envelope power and the bandwidth of an amplitude-modulated transmission.

How the calculation works

  • Enter the carrier power and the modulation depth.
  • Enter the highest audio frequency.
  • The calculator gives the total power, the sideband powers, the efficiency, the peak envelope power, the bandwidth and the check for overmodulation.

Example

A 100 W carrier modulated at 80 % has m² / 2 = 0.32, so the sidebands add 32.00 W and the total is 132.00 W, with 16.00 W in each sideband. The efficiency is only 24.2 %. The peak envelope power is 100 × 1.8² = 324.00 W, and with audio up to 5 kHz the bandwidth is 10.00 kHz.

Why it matters

The calculator helps radio amateurs, broadcast engineers and electronics students who size an AM transmitter, compare modulation methods or study why single-sideband saves power.

Good to know

AM wastes power in the carrier, which is why single-sideband and suppressed-carrier systems were developed: they send only the sidebands, saving power and bandwidth. Real speech has a low average modulation depth, often 30 to 40 %, so the average efficiency is lower than the value at the peak depth. Broadcast AM uses processing to keep modulation high without overmodulating. The formulas assume a single tone, and a speech signal has a different power distribution. Remember that the receiver sees only the demodulated sidebands, so the efficiency is a good measure of how useful the power is. Depth is the ratio of the peak amplitude of the message to that of the carrier.

The FM bandwidth calculator covers frequency modulation, the dBm converter switches between watts and dBm, the SNR calculator converts ratios and the decibel addition calculator adds levels.

Frequently asked questions

How is the power split in AM?

The carrier keeps its power Pc, and the two sidebands add Pc × m² / 2 together, where m is the modulation depth as a fraction. At 100 % modulation, the sidebands hold half the carrier power, so one third of the total. The carrier itself carries no information.

What is the peak envelope power?

It is the power at the highest peak of the envelope, Pc × (1 + m)². At 100 % modulation it is four times the carrier power, which sets what the transmitter and its amplifier must handle without distortion.

What happens above 100 % modulation?

The envelope would need to go below zero, so the carrier is cut off during part of the cycle. This overmodulation creates distortion and spreads energy outside the channel, which is why transmitters use limiters.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.